Monogram Installation Instructions
Stainless Steel Side Panel Kits
⚠️ Electrical Shock Hazard
Death or serious injury can result from failure to follow these instructions.
- Disconnect power before installing this panel.
- Replace all parts and panels before operating.
⚠️ Cut Hazard Warning
Panel edges along stamp/cut-out areas may be sharp. Avoid placing hands, fingers or other appendages near these areas. Wear gloves for installation. Failure to do so can result in cuts.
INSTALL SIDE PANELS
- Disconnect power from appliance before installing panel.
- Loosen the top hinge cover by loosening the screws. Diagram shows loosening screws on the top hinge cover.
- Remove the top rear case bumper by removing the hex screw. Discard bumpers and screws. Diagram shows removing the hex screw from the top rear case bumper.
- Remove the paper from the adhesive strips on the side panels.
- Align the panels to the unit as shown. Diagram shows aligning the left and right hand panels to the refrigerator unit, indicating adhesive strips.
- Press with force on adhesive areas starting with the top front section to secure the panels.
- Secure the top hinge cover.
- Remove protective film by starting in the front/top corner and peeling downward toward the back/bottom corner.
- Connect appliance to power.