Technical Drawing: Hole Pattern Specifications
This document provides a technical specification for a component featuring specific hole patterns and dimensions. The primary purpose is to outline the precise placement and size of holes required for assembly or mounting.
General Instructions
To ensure accurate printing of this technical drawing for actual size measurement:
- Open the PDF in Adobe Acrobat (a free application).
- Navigate to File >> Print.
- Under the 'Page Size & Handling' section, select the Actual size option.
- Click Print to proceed.
- After printing, measure the 6-inch line provided on the right side of the document to verify the print accuracy.
Hole Pattern Details
The drawing displays three identical sections, each illustrating a pattern of holes. Key dimensions are provided for clarity:
- Large Central Holes: These holes have a diameter of Ø24 mm (approximately Ø15/16 inches).
- Smaller Outer Holes: There are four smaller holes positioned around the central hole in each pattern. These have a diameter of Ø6 mm (approximately Ø1/4 inch).
- Intermediate Holes: Two intermediate holes are shown, one above and one below the central hole in each pattern. These have a diameter of Ø7 mm (approximately Ø9/32 inches).
Each hole is marked with crosshairs indicating its center point for precise alignment.
Brand Information
This drawing is associated with GoWesty, a premier parts supplier for VW Bus, Vanagon, and Eurovan vehicles.
