SHARPER IMAGE® POWER PERCUSSION PRO+ HOT + COLD PERCUSSION MASSAGER

Introduction and Operation

Please read all instructions and warnings prior to use. Keep this manual as it contains important information for future reference.

The Future of Recovery

Step 01: Charging the Massager

Plug the included USB-C charging cable into the input port on the bottom of the massager handle. Connect the other end to a standard USB-C power adapter (not included) and plug into a wall outlet to begin charging. A lightning bolt icon on the display will flash while charging and turn solid white when charging is complete. Charging speeds may vary. For fast charging, use a compatible adapter (e.g., 5V/3A, QC 3.0, or PD 9V/2A).

Important: If the display does not light up when plugged in, the power adapter may be incompatible. Unplug immediately and use a different adapter. Only charge with compatible power adapters.

[Visual Description: A diagram shows a USB-C cable connecting a massager handle to a power adapter (not supplied).]

Step 02: Selecting and Attaching Accessories

Power off the massager before changing attachments. Select and securely plug the desired attachment into the front of the massager. Twist and pull to remove attachments.

Important: To use the Hot + Cold attachment, power off the massager, insert the attachment firmly, and power on. The TEMP icon will light up if properly connected. If not, turn off and reconnect.

Press the hot or cold button to switch between heating and cooling modes. Press the same button repeatedly to cycle through 3 levels for each mode. The ring on the front of the massager will light up red for hot or blue for cold.

[Visual Description: A diagram shows a massager handle with a USB-C port, a TEMP icon, and a ring light. It also shows a phone icon with a Bluetooth symbol.]

Step 03: Operating the Massager

To power on, press and hold the power button until the display turns on. Press the power button again to cycle through 6 massage intensity levels. Press and hold the power button to turn off.

Note: The massager features anti-stall technology; massage speed automatically increases with applied pressure to prevent motor stalling.

[Visual Description: A diagram of the control panel shows a Cool button, Cool level indicator, LED Display Intensity Level (showing 6 levels), Heat button, Heat level indicator, Charging indicator, and Power button.]

Using Heat and Cool Modes

To use heat mode, press the heat button. Continue pressing to cycle through 3 heat levels or turn off. For cool mode, press the cool button and cycle through 3 cool levels or turn off.

The number of red LEDs indicates the heat level, and the number of blue LEDs indicates the cool level. Wait a few seconds at each level for the attachment to reach temperature.

CAUTION: Never continue cold or heat therapy for more than 20 minutes at a time. If skin becomes bright pink or red, stop use immediately.

Usage Guidelines

Use the massager for up to 60 seconds per body area. Enjoy your massage for up to 10 minutes.

Do not use on the neck, head, or any hard or bony areas of the body.

Safety Warnings

• Not a children's item. Keep out of the reach of children.
• Always wear clothing when using. Do not use on bare skin to avoid possible irritation.
• As with any massage, bruising may occur. Test your comfort level and check targeted areas often. Stop massage immediately if you feel any increase in physical discomfort or pain.
• Do not use attachments other than those included.
• Do not fall asleep while using.
• Do not leave this item unattended when plugged in.
• Always allow the item to cool if it becomes too hot.
• Do not expose to extreme temperatures or moisture.
• Keep away from sources of water and heated surfaces.
• Never touch the charging cable or ports with wet hands.
• Do not carry this item by the charging cable or attachments.
• For indoor use only.
• Thoroughly inspect products before every use. If the product appears worn, frayed, splintered, cracked, or broken, discontinue use and discard immediately.
• This product is not intended to treat, cure, or prevent medical conditions.
• Do not use if pregnant or have an injury or illness. Consult your physician if you have a medical condition that may prevent safe use.

Attachments and Battery Health

What You Get

• a. Power Percussion Pro+
• b. Interchangeable attachments
• c. USB-C charging cable
• d. Carrying case

[Visual Description: Diagrams show the four components: a massager handle, various attachments (Hot+Cold, Round, Bar, Cone), a USB-C cable, and a carrying case.]

[Note: Accessory type and quantity may vary depending on the model.]

Attachment Types

• Hot + Cold: Heat or cool therapy for advanced relief.
• Round: Good for Back, Glutes, Arms, Thighs. Low muscle impact for larger areas and overall comfort.
• Bar: Good for Chest, Shoulders, Back. Medium muscle impact for deeper recovery.
• Cone: Good for Feet, Calves, Trigger Spots. High muscle impact for intense muscle penetration.

Battery Health

Your massager uses a lithium-ion battery pack for cordless convenience and extended use. To maintain charge capacity and prevent damage, lithium-ion batteries must be regularly used and recharged.

For optimal battery health, keep the battery at approximately 50% charge when not in use. Batteries naturally lose charge; if not using for an extended period, check the massager at least every 30 days and recharge as needed to maintain a 50% charge, but do not overcharge.

Important: Do NOT store the battery with above 60% or below 40% charge for extended periods, as this can irreparably damage the battery.

For battery health, store the massager in a cool, dry place with consistent temperatures (40°F-70°F / 5°C-20°C) and relative humidity at 70% or lower.

Rechargeable Battery Warnings

• This product contains non-replaceable batteries. Risk of fire and personal injury if battery is punctured, damaged, or misused.
• Do not dismantle, crush, incinerate, or short-circuit the battery.
• Never expose the battery to extreme temperatures or moisture.
• Keep away from flammable materials and direct sunlight.
• Only charge using the provided charger, cable, and/or adapters.
• Rechargeable battery is only to be charged by an adult. Adult supervision is required while charging.
• Allow the battery to cool to room temperature before charging.
• Charge on a non-flammable surface and keep away from flammable products.
• Discontinue charging if the battery becomes hot, swells, smokes, or gives off a strong odor.
• Regularly examine battery chargers for damage to the cord, plug, enclosure, and other parts. Do not use damaged chargers.
• Recycle or dispose of the battery according to federal, state, and local laws.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Care Instructions

• Spot clean only. Unplug and wipe with a damp cloth.
• Air-dry only. Never place in a dryer.
• Allow to dry fully before charging.
• Do not submerge in water.
• Do not use detergent or soap when cleaning.