iHome VAC SV1 Cordless Multi-Use Rechargeable Vacuum

SAFETY

For household use only.

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.

WARNING - To reduce the risk of fire, electric shock, or injury:

1. For INDOOR use ONLY. Do not use the appliance in outdoor or industrial environments. Do not use the appliance on wet surfaces or surfaces with standing water.
2. Do not allow to be used as a toy. Close attention is necessary when used by or near children, pets or plants.
3. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
4. Do not use with a damaged cord or plug. If appliance has been dropped, damaged, left outdoors or is not working as it should, contact customer service center.
5. Do not handle charger, including charger plug, and charger terminals with wet hands.
6. Do not block openings. Stop use if openings become blocked. Clean and remove any blocked objects according to the enclosed manual instructions.
7. Keep hair, loose clothing, fingers, and all parts of your body away from openings and moving parts.
8. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
9. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
10. Ensure the switch is in the off position before charging, picking up or carrying the appliance. Carrying the appliance with your finger on the switch or powering on the appliance with the switch on may cause accidents.
11. For the purposes of recharging the battery, only use the detachable power adapter provided with this appliance.
12. Under improper usage, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid comes into eye contact, seek medical help. Liquid ejected from the battery may cause irritation or burns.
13. Do not use the appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
14. Do not expose the appliance to fire or excessive heat. Exposure to fire or temperatures above 250°F (121°C) may cause an explosion.
15. Only charge, store or use the appliance in a dry indoor area where the temperature is higher than 39.2°F (4°C) but lower than 104°F (40°C). The charger is for indoor use only. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.
16. Do not use appliance unless all filters are in place.
17. Have servicing performed by a qualified repair person using only identical replacement parts provided by the manufacturer. This will ensure that the safety of the product is maintained.
18. Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care.
19. Always turn off this appliance before connecting or disconnecting the motorized nozzles and attachments.

FCC Information

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

PRODUCT OVERVIEW

The iHome VAC SV1 is a cordless multi-use rechargeable vacuum cleaner. The following components are included:

• 1: Rechargeable battery
• 2: LED indicators
• 3: HEPA filter assembly
• 4: On/off button
• 5: Speed control button
• 6: Dust canister release
• 7: Dust canister
• 8: Dust canister cover latch
• 9: Tube release
• 10: Metal tube
• 11: Floor brush release
• 12: Full-size power brush
• 13: Crevice tool
• 14: Nozzle (for crevice tool)
• 15: Brush (for crevice tool)
• 16: Charging wall mount
• 17: Mini power brush
• 18: Power adapter

The product image shows the main vacuum unit with the handle containing the battery, controls, and dust canister. The metal tube attaches to the main unit, and the floor brush or other attachments connect to the end of the tube.

GETTING STARTED

Vacuum assembly

Follow these steps to assemble the vacuum:

1. Tube Installation: Insert the metal tube into the main unit until you hear a click.
2. Brush Installation: Insert the desired brush attachment (e.g., full-size power brush) into the end of the tube until you hear a click.
3. Battery Installation: Slide the rechargeable battery up into its designated slot in the main unit until you hear a click. Ensure the latch is fully engaged on the underside.

Battery charging

• Plug the power adapter into a functioning wall outlet.
• Before first use, the battery may require up to 4 hours to fully charge.
• While charging, the vacuum enters standby mode. Remove from charging to operate.

Charging without Wall Mount

Connect the power adapter plug directly into the jack on the base of the vacuum handle. Charging status LEDs, located on the top of the vacuum, will indicate the charging level. Four LEDs will remain lit solid when the battery is fully charged.

Charging with Wall Mount

(For wall mount installation, see next section)

Connect the power adapter plug directly into the jack on the top of the wall mount. Place the vacuum onto the charge mount. Charging LEDs on the vacuum will turn on when the charge contacts are properly seated.

Installing the wall mount (optional)

1. Assemble the two parts of the wall mount as shown in the diagram.
2. Determine the best wall location for mounting the dock, ensuring a nearby power outlet for the power cable.
3. It is recommended to mount the dock at least 48 inches from the screw hole to the floor. This mounting height should ensure that the vacuum does not touch the floor while docked.
4. Install the wall-mounted dock to the wall using the provided screws and anchors.

Warnings:

• If you are unsure about properly installing drywall anchors and screws, do not mount the dock. Consult a professional for support.
• Ensure the wall area surrounding the mounting location is free of gas, water pipes, electrical cables, or wires.

USING YOUR VACUUM

Operation

Note: Designed for indoor use only. Do not vacuum liquids.

• Press the power button to turn the vacuum on. Press again to turn it off.
• Press the speed control button to toggle between Normal and Max modes.

MAINTENANCE

Emptying the dustbin

Note: Empty your dustbin and clean filters regularly to ensure optimal performance and longevity of your vacuum.

Note: Remove tube/brush attachments before emptying the dustbin.

Hold your vacuum over a trash bin. Push down on the dustbin cover latch to release it. Gently tap on the dustbin to ensure all debris is emptied.

MAINTENANCE

Cleaning the filter system

The filter system includes a dust canister, HEPA filter, sponge filter, and screen filter.

1. Release Dust Canister: While pressing the dust canister release button, rotate the canister and pull it down to release it from the main unit.
2. Remove Filters: Remove the dust cap. Then, rotate the HEPA filter and remove it by pushing up from underneath. Remove and identify the sponge and screen filters from within the canister.
3. Clean Filters: Rinse the HEPA, sponge, and screen filters under running water. Squeeze excess water from the sponge filter. Allow all filters to dry completely before reassembling.
4. Reassemble: Insert the filter assembly back into the dustbin, ensuring the two tabs are lined up correctly. Snap the dustbin back onto the vacuum by aligning the notches. Rotate the primary filter back into place and then rotate the dust cap into place.

Cleaning the floor brush

1. Detach Brush: Remove the floor brush from the metal tube by pressing the release button and pulling the parts apart.
2. Remove Cover: Remove the clear cover by pulling back on the rounded portion.
3. Remove Brushroll: Remove the brushroll by pushing upwards from the bottom left.
4. Clean Debris: Remove any debris or hair wrapped around the roller using a cleaning tool.
5. Clean Housing: Wipe down the inside of the brush housing.
6. Check for Blockages: Ensure there is no debris lodged in the neck of the brush assembly or in the metal tube.
7. Reinstall Brush: Reinstall the brush assembly by matching the shapes as shown in the diagram (flower shape to flower shape, shaft shape to shaft shape).

TROUBLESHOOTING

Questions? Contact customer service

Web/Email: iHomeclean.com

Phone: 877-370-4580

WARRANTY

The One (1) Year Limited Warranty applies to purchases made from authorized retailers of Silver Point Innovations LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable. Registration of your product online at www.ihomeclean.com is recommended.

SilverPoint warrants this product to be free from defects in workmanship and materials, under normal household use and conditions, for one (1) year from the date of original purchase, provided it is maintained according to the requirements outlined in this User Manual. Should this product fail to function in a satisfactory manner, contact the customer service team at 877-370-4580 for assistance. SilverPoint will repair or, at its discretion, replace the product if service is required due to a defect or malfunction during the warranty period.

The One (1) Year Limited Warranty is subject to the following conditions and exclusions:

The original unit and/or non-wearable parts deemed defective, at SilverPoint's sole discretion, will be repaired or replaced up to one (1) year from the original purchase date. If a replacement unit is issued, the replacement product will be warranted for the remainder of the original warranty period or thirty (30) days from the date of shipment of the replacement product, whichever is longer. SilverPoint reserves the right to use new, refurbished, or used parts in good working condition to repair or replace any product.

Exclusions:

• Normal wear and tear of wearable parts (such as batteries, brushes, HEPA filters, pads, etc.) that require regular maintenance and/or replacement are not covered by this warranty. Replacement parts are available for purchase at ihomeclean.com.
• Any unit that has been tampered with or used for commercial purposes.
• Damage caused by misuse, abuse, negligent handling, failure to perform regular maintenance (e.g., not cleaning filters), or damage due to mishandling in transit.
• Consequential and incidental damages.
• Defects caused by repair persons not authorized by SilverPoint.
• Products purchased, used, or operated outside of North America.

Claiming Warranty Support:

To initiate a warranty claim, call 877-370-4580 with the product on hand. The original receipt is required as proof of purchase.

The One (1) Year Limited Warranty does not cover the cost of shipping the product to the service center or its return to the owner. Contact Customer Service at 877-370-4580 for shipping instructions.

Disclaimer: This warranty is valid only in the United States of America and does not extend to owners other than the original purchaser. SilverPoint and its affiliates, contractors, resellers, officers, directors, shareholders, members, or agents will not be liable for any consequential or incidental damages, lost profits, or exemplary or punitive damages. (Some states may not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply.) This warranty grants specific legal rights, and you may also have other rights that vary by state. By purchasing the SilverPoint product, you acknowledge and agree to fully and completely abide by this disclaimer of warranty.