PITAKA Aramid Fiber Magnetic Power Bank Quick Guide

1. Charging the Power Bank

Connect the power bank to a power adapter via the Type-C port and plug the adapter into the electrical socket.

[Diagram: A power bank is shown connected via a USB-C cable to a power adapter, which is plugged into a wall socket.]

2. Charging Your Phone

Attach the power bank to the back of your iPhone 12/13/14/15/16 (using a MagSafe case or not). Max power: 15W.

[Diagram: A power bank is shown magnetically attached to the back of a smartphone.]

Note: Your phone will start charging automatically once attached to the power bank. Remove it to stop charging. No need to press any buttons.

Or connect the power bank to your phone via a charging cable. Max power: 20W.

[Diagram: A power bank is shown connected to a smartphone via a USB-C charging cable.]

The magnetic function is only used to adjust the charging position of the phone.

3. Buttons & LED Indicators

Click the power button on the power bank to see the battery charging level.

[Diagram: A power bank is shown with a single button, indicating its location.]

Note:

• The Type-C port on the power bank is used for input and output.
• The power bank has built-in safety features, including overvoltage and overcurrent protection, overpower and short circuit protection, and electromagnetic field blocking.

Regulatory Compliance

IC WARNING

ISED Canada Statement: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

IC Radiation Exposure Statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Déclaration d'ISED Canada

Cet appareil contient des émetteurs/récepteurs exemptés de licence qui sont conformes aux RSS exemptés de licence d'innovation, sciences et développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: (1) ce dispositif ne peut pas causer d'interférence. (2) ce dispositif doit accepter toute interférence, y compris l'interférence qui peut causer un fonctionnement indésirable du dispositif.

Déclaration d'exposition aux radiations IC: L'appareil a été évalué pour répondre aux exigences générales d'exposition aux RF. L'appareil peut être utilisé sans restriction dans des conditions d'exposition portables.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FCC ID: 2ARI5-PB2

IC : 33172-PB2

[FCC Logo] [CE Logo] [CQC Logo] [RoHS Logo]