LUmITeCH EPIC 595x595 Ceiling Light Instruction Manual

Contents hide

1 LUmITeCH EPIC 595×595 Ceiling Light

2 Mounting Instruction

3 Removing opal cover

4 Documents / Resources

4.1 References

5 Related Posts

LUmITeCH EPIC 595×595 Ceiling Light

LUMITECH APS
ODINSVEJ 2
DK 6950 RINGKOBING
Phone: +45 97 32 39 40
WWW.LUMITECH.DK

Mounting Instruction

Attention

Installation of Luminaire and servicing of LED Components, may only be performed by an qualified Person.
During the complete Luminaire installation process, the Luminaire must always be without Power.

Always Power off Luminaire before opening or accessing any Part of the Luminaire during Service routines.
Non-user replaceable Lightsource: The Lightsource contained in this Luminaire shall only be replaced by the Manufacturer, or his Service agent or a similar qualified Person.

” ESD sensitive components” avoid unnecessary touching LED Boards and LED Drivers.
Optical Lenses, other forms of Optics and Grids, must always be mounted when Luminaire is in operation.

Luminaire with DALI Driver must have an good active ground/earth Connection.

Removing opal cover

Gently push/flip to release the tabs and then flip the opalcover out.

Installation and connection in 600×600 (Visible T – 15/24mm) ceiling.

Connection through 2 pcs. grommets or via Linect system (Linect connection is made on the backside of the luminaire). (When connecting with cable: Pay attention that the cable(s) are mounted/fixed so they can’t make shadows on the opalcover).

Installation of geartray (if ELFIX luminaire), and installation of the opalcover.