Myka 45 – Installation Instructions
Model MK45-XX
Myka 45
MK45-XX Linear Valance Illumination System
Please read all instructions prior to installation and keep for future reference!
- PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- USE ONLY WITH CLASS 2 POWER UNIT.
- 24 VOLTS DC.
- SUITABLE FOR DAMP LOCATIONS.
- SURFACE MOUNT ONLY.
- SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE WHEN USED WITH TAPE OUTPUTS 5.7W/FT OR LESS
1.1 Determine the location of where the fixture(s) will be installed. Lay the fixture(s) on the surface, and make any necessary reference marks for the concealed bracket.
Make marks 4” from each end of the fixture(s) and also every 23” in between. Use the fixture profile and mounting bracket detail, for any additional details.
1.2 Lay the concealed bracket onto the reference mark points and secure using the provided hardware.
2.1 Align the mounting brackets to the marks, followed by securing each mounting bracket with 2 screws. Snap the extrusion into the mounting brackets.
2.2 To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion pops up.
3.1 If necessary make any pass through holes for wire lead/connector to the surface, depending on the power feed option. Then snap the fixture into the concealed mounting bracket to secure in place.
4
4.1 Follow one of the two options to connect the fixture to the power supply.
Option 1 – Secure female quick connect to male quick connect. Feed male quick connect wire through conduit to power supply.
OR
5.1 Connect +24 VDC red wire from the fixture to the power supplies +24 VDC red wire using a wire nut. Then connect the -24 VDC black wire from the fixture to the power supplies -24 VDC black wire using a wire nut.
power supplies at the end of the run
power supplies in the middle of the run
consecutive layout, NOT RECOMMENDED
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
REV0.2
02022024
Documents / Resources
 |
luminii MK45-XX Linear Valance Illumination System [pdf] Instruction Manual MK45-XX Linear Valance Illumination System, MK45-XX, Linear Valance Illumination System, Valance Illumination System, Illumination System |