luminii LL60X2 WET-T LineLED 60X2 Series Double Row Linear LED strip
Models LL60X2 WET-T
Please read all instructions prior to installation and keep for future reference
Installation Instructions
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLTION TO PREVENT ELECTRICAL SHOCK.
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR DAMP LOCATIONSFPO
- FOR UNDER CABINET OR SHELF MOUNT
- CONFORMS TO UL STD 2108. CERTIFIED TO CSA STD C22.2 NO.250.0.
- Clean the area thoroughly where the lineLED will be installed. Remove the paper backing from the lineLED and firmly press down making sure there are no air
bubbles that can cause surface irregularities. Do not remove the adhesive, removing the adhesive may cause arcing of the lineLED tape. - If necessary, add a mounting clip every 12” for additional support
Connect the positive red wire to the RED low voltage wire from power supply. Also, connect the negative black wire to the BLACK low voltage wire from power supply.
Always ensure power to power supply is off! Follow diagrams to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side.
LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Documents / Resources
 |
luminii LL60X2 WET-T LineLED 60X2 Series Double Row Linear LED strip [pdf] Instruction Manual LL60X2 WET-T LineLED 60X2 Series Double Row Linear LED strip, LL60X2 WET-T, LineLED 60X2 Series Double Row Linear LED strip, Double Row Linear LED strip, Linear LED strip |
