LineLED Wet 24V – Installation Instructions
Models LL42WET-T
LL42WET-T Line LED Wet Location Linear LED Strip Light
Please read all instructions prior to installation and keep them for future reference!
- THE PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT THE FUSE BOX PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR WET LOCATIONS
- FOR UNDER-CABINET OR SHELF MOUNT
- AVOID EXPOSURE TO DIRECT SUNLIGHT
- NOT SUITABLE FOR APPLICATIONS WHERE LEDS CAN BECOME SUBMERGED
NOTE: Avoid bending the line in sharp horizontal angles, doing so can cause damage to the LEDs.
1.1 Remove paper backing from the line and firmly press down. Make sure there are no air bubbles that can cause surface irregularities to the line. Do not remove the adhesive, removing the adhesive may cause arcing of the lineLED tape.
1.2 If necessary, add a mounting clip every 12” for additional support.
2.1 Always ensure power to the power supply is off! Follow diagrams to connect power feed wires to the power supply. Refer to power supply instructions for wiring line voltage side.
* LUMINII RESERVES THE RIGHT TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
REV0.1 02072022
7777 Merrimac Ave Niles, IL 60714 T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Documents / Resources
 |
luminii LL42WET-T Line LED Wet Location Linear LED Strip Light [pdf] Instruction Manual LL42WET-T, Line LED Wet Location Linear LED Strip Light, Location Linear LED Strip Light, Linear LED Strip Light, LED Strip Light, LL42WET-T, Strip Light |
