Z207 BLUETOOTH®
COMPUTER SPEAKERS
Complete Setup Guide
KNOW YOUR PRODUCT
CONNECT THE SPEAKERS
- Connect the DC power plug to the back of your right speaker and connect your AC adapter to the electrical outlet.
- Connect to the 3.5 mm audio jack on your source device using the 3.5mm auxiliary input on the back of the right speaker.
- (Optional) Connect your headphones to the headphone jack at the front of the right speaker.
- Turn the speaker on using the power knob.
- To pair your devices with speakers using Bluetooth, press the Bluetooth pairing button for 3 seconds until the LED starts blinking. Turn on Bluetooth on your device and select “Logi Z207” to connect to it. The LED will then turn to a steady blue light after pairing.
ADJUST THE VOLUME
- Increase (or decrease) the volume of speakers by rotating the volume control knob clockwise (or counter-clockwise) on the right speaker.
www.logitech.com/support/Z207
© 2019 Logitech. Logitech, Logi and other Logitech marks are owned by Logitech and may be registered. All other trademarks are the property of their respective owners. Logitech assumes no responsibility for any errors that may appear in this manual. Information contained herein is subject to change without notice.
Documents / Resources
 | Speakers Computer |
References
- Products - Logitechwww.logitech.com
- User Manualmanual.tools
Published: July 16, 2021
Updated: July 17, 2021
از کجا بفهمیم اسپیکر سینما خانواده روشنه ؟
How can I tell if the Logitech Z207 speakers are turned on?
To determine if your Logitech Z207 Bluetooth Computer Speakers are turned on, check the Indicator light (LED) located on the front of the right speaker, just above the power/volume knob.
If the LED is not lit, the speakers are likely turned off or not receiving power from the AC adapter.
Note: While the user mentioned "home theater," the manual provided is for the Z207 computer speakers; these steps apply specifically to that model.
Read the full Q&A page