MP0058 Field Termination Plug
Instruction Manual
MP0058 Field Termination Plug
- Insert cable into nut
- strip off 1.2 inch(30mm) of cable jacket, fold back braid and drain wire.
- paste copper foil on the braid and ground wire and cut off the excess weave and ground wire
- Fan out all four twisted pairs, following the color coding label and allocate each
- Across the holder, according the color marks of T568A or T568B or PROFINET
- following the color coding label and allocate each conductor into proper slots on wiring cap. Trim the ends of conductors.
- Place wiring cap on plug
- Close plug cover, make sure the drain wire is in proper contact with grounding clip on plug.
- Screw the nut tight
- Use angled accessories,
- Can achieve 90 degree bends in 4 different directions
- Screw the nut tight
Documents / Resources
 |
Logilink MP0058 Field Termination Plug [pdf] Instruction Manual MP0058, Field Termination Plug, MP0058 Field Termination Plug, Termination Plug, Plug |
