LiveFree-logo

LiveFree T601-YK118 Cellular-Based Personal Emergency Response System

LiveFree-T601-YK118-Cellular-Based-Personal-Emergency-Response -System-product

Specifications

  • Front Size: 295*129
  • Single page size: 147.5*129
  • Weight: 157g

Pairing Mode

  1. Connect the power adaptor to the Duo and turn on the power switch, and choose 4G or tel by moving the portion switch.LiveFree-T601-YK118-Cellular-Based-Personal-Emergency-Response -System-fig- (1)
    • a. Press and hold the EZ Duo pair button for 3 seconds; the green LED starts flashing.
    • b. Press and hold the RF device pair button for 3 seconds.
    • c. EZ Duo short beep, green and red LED flash 2 seconds. RF Paired.LiveFree-T601-YK118-Cellular-Based-Personal-Emergency-Response -System-fig- (2)
      Notes:
    • d. Repeat step b to continue to pair more RF devices.
    • e. Each operation should be done within 5 seconds, or it will exit the pairing.
    • f. At pair mode, if you press the cancel button, it will delete all the group RF devices.LiveFree-T601-YK118-Cellular-Based-Personal-Emergency-Response -System-fig- (2)
  2. Press and hold the red SOS button on the device or the button on the pendant to make a test call.

Get help in three easy steps.

LiveFree-T601-YK118-Cellular-Based-Personal-Emergency-Response -System-fig- (4)

FCC Warning

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules.

Operations are subject to the following two conditions
This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled instrument. This equipment should be installed and operated with a minimum distance of 20cm between the radiator& your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Please test your pendant monthly.

Documents / Resources

LiveFree T601-YK118 Cellular Based Personal Emergency Response System [pdf] User Guide
DUO250, XTXDUO250, duo250, T601-YK118 Cellular Based Personal Emergency Response System, T601-YK118, Cellular Based Personal Emergency Response System, Based Personal Emergency Response System, Personal Emergency Response System, Emergency Response System, Response System, System

References

Leave a comment

Your email address will not be published. Required fields are marked *