Linklemo Smart Camera APP Instruction Manual

Linklemo Smart Camera APP

Linklemo Smart Camera APP

Download and Install thc APP

Use the browser, scan the QR code to download and install it; or search “Lianle.”
Download “Linklemo” from the Apple Store/Google Play/mobile app store and install it

QR Code

SymbolAPP icon: “Linklemo”

APP Connection

  1. Open the APP, register and log in;
  2. Open the mobile phone settings to connect to 2.4G WiFi(wireless fidelity) and turn on the mobile phone Bluetooth;
  3. Key Description:
    Power on: Press and hold the bottom button for 2 seconds to power on;
    Shutdown: after the boot, long press the button to 3 seconds when the indicator light will go off, release your hand to Shutdown;
    Enter the distribution mode: press the button for 5 seconds until the blue indicator flash enters the distribution mode.
  4. Click “Add Device” in APP to automatically scan devices until the device is scanned (FIG.1), click “Bind Now” corresponding device and click “Next”(FIG.2).After adding the successful blue indicator light son, you can customize the device name (FIG.3), which means successful addition.
    APP Connection
    If the device cannot be added for a long time, you need to press the button long enough for5 seconds to enter the distribution network mode again.
  5. AP mode [no network connection]: press the switch button for 2 seconds, then press the reset button for 5 seconds until the blue indicator flash; find and connect the wifi before “LLM _”with the password 12345678; Open the APP to use it.
    Note: 1.When using the wireless connection mode, you need to maintain the WiFi connection; 2.When you return to the APP, select Cancel when prompting the networking popup.
  6. Matters Needing Attention
    1. Ensure that Bluetooth is turned on and WiFi network environment is good. The device does not support 5G WiFi;
    2. Try not to stick to the metal door above the installation;
    3. You must set permissions through the APP to normally use the product;
    4. Ensure that the Power Supply Issue and the overspills connected;
    5. After installation pasta off the lens protective film before use.

Documents / Resources

PDF thumbnailSmart Camera APP
Instruction Manual · Smart Camera APP, Camera APP

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.