lightspeed -LOGOQuick Start Guide
995 Access
Instructional Audio System

CONNECT POWER TO THE 955 ACCESS

Connect the power supply to 955 Access and plug the cord into an AC outlet.

lightspeed 955 Access Instructional Audio System-

955 Access will power on and the power light will glow.

lightspeed 955 Access Instructional Audio System-POWER LIGHT

USING THE FLEXMIKE

lightspeed 955 Access Instructional Audio System-ALIGN WITH

Remove the microphone from the charger. Press the mute button to unmute, hold near your mouth and begin speaking.

lightspeed 955 Access Instructional Audio System-POWER LIGHT

USING THE SHAREMIKE

lightspeed 955 Access Instructional Audio System-SHAREMIKE

Remove the microphone from the charger and press the mute button to begin speaking.

lightspeed 955 Access Instructional Audio System-BUTTON

CHARGE MICROPHONES NIGHTLY

Place the microphones into the cradle charger. The power status light will glow red when it is charging. It takes about 5-6 hours to fully charge the microphone battery.

When charging is complete, the power status light will glow green.

lightspeed 955 Access Instructional Audio System-NIGHTLY

USING A WIRELESS AUDIO LINK

You can connect your 2nd microphone to your computer’s USB port to enable a wireless 2-way audio link.
SEND AUDIO FROM THE COMPUTER to the 955 Access to ensure all audio from the computer (videos, video conferencing, audiobooks, music, etc) can be played through the Lightspeed 955 system and speakers.
SEND AUDIO TO THE COMPUTER from the 955 Access to ensure the teacher’s Flexmike and any student microphones are clearly picked up by a video conferencing solution.

Connect the microphone to your computer using a USB-C cable. Open your computer sound settings to select FlexmikeAudio as the microphone and speaker.

lightspeed 955 Access Instructional Audio System-CONECT

USB cable sold separately. Lightspeed offers a USB-A to USB-C cable for sale (part #USBC)

PAIRING MICROPHONES TO 955 ACCESS

Your system is shipped with microphones and base units pre-paired for quick and easy use. If you ever need to pair new components, follow this pairing process:

  1. With a paperclip, push the register button on the back of 955 Access.
    lightspeed 955 Access Instructional Audio System-paper
  2. From a powered-off state, press and hold the power button for five seconds until the mic 1 and mic 2 lights start flashing, then release the button and let the pairing process finish.
    lightspeed 955 Access Instructional Audio System-POWER BUTTON
  3. The ”status” light on 955 Access will light up indicating the pairing process is complete. The mic 1 or mic 2 light on the microphone will stay illuminated.

lightspeed 955 Access Instructional Audio System-microphone

lightspeed 955 Access Instructional Audio System-qrhttp://www.lightspeed-tek.com/955N-usermanual

lightspeed -LOGO
QS0621US01-1

lightspeed 955 Access Instructional Audio System-br

Documents / Resources

lightspeed 955 Access Instructional Audio System [pdf] User Guide
955 Access, Instructional Audio System

References

Leave a comment

Your email address will not be published. Required fields are marked *