Lightdot B0DXVS4NGS Remote Control
Product Specifications
- Remote Control Setting
- ON/OFF Normal Mode Hold Time
- Sensor Mode: 5S, 30S, 1min, 5min, 10min
- High Sensitivity Detection Area: 25%, 50%, 75%, 100%
- Low Sensitivity Detection Area: 25%, 50%, 75%, 100%
Product Usage Instructions
- ON/OFF Normal Mode:
- To switch to constant on/off mode, press the ON/OFF button. The sensor will be disabled in this mode. To turn off and then turn on the light to switch to constant on mode.
- Sensor Mode:
- To activate the sensor mode, short-press the Sensor Mode button. The sensor will start working. To exit sensor mode and return to the last settings, short press the Sensor Mode button again.
- Hold Time Setting:
- To set the hold time, choose from options: 5S, 30S, 1min, 5min, or 10min.
- High Sensitivity Detection Setup:
- To enable high sensitivity detection, press the HS button and select the desired range from 25%, 50%, 75%, or 100%.
- Low Sensitivity Detection Setup:
- To enable low sensitivity detection, press the LS button and select the desired range from 25%, 50%, 75%, or 100%.
OVERVIEW
FUNCTION
FAQs
- Q: How do I switch between normal mode and sensor mode?
- A: Press the ON/OFF button for normal mode and short press the Sensor Mode button to activate sensor mode.
- Q: How do I adjust the hold time?
- A: Use the remote control to set the hold time to your preference: 5S, 30S, 1min, 5min, or 10min.
- Q: How can I change the sensitivity settings?
- A: Press either the HS or LS button to enter high or low-sensitivity detection modes. Then select the desired detection range.\
Documents / Resources
 |
Lightdot B0DXVS4NGS Remote Control [pdf] Instructions B0DXVS4NGS, B0DXVS4NGS Remote Control, Remote Control, Control |
