LifThor Phantom 4 Tripltek Mount User Manual
Content
- Tablet clamp Compatible with 7.9” up to 13” devices
- Mounting bracket
- Screws (x2) & washer
- Hex Key (x2)
How To Assemble
Remove the OEM bracket from the Remote control with the help of a screwdriver. (not included).
With the tips of your fingers unscrew the rear support of the bracket to remove the OEM bracket.
Align the LifThor Lite mounting bracket and secure lightly with the smaller screw with the smaller Hex Key (Allen key) provided.
Secure the rear end of the bracket with the bigger screw and washer provided, once secured in place tighten the front screw by pushing down the bracket to align properly.
Unscrew the tightening ring from the back of the tablet clamp and place it on the ball joint.
Attach the clamp to the ball joint and screw the ring back to secure the clamp position / angle.
The clamp has two mechanisms to ensure your tablet sit secure and in place.
The first mechanism is the ratchet part, to adjust to the size of your tablet. We recommend setting it a little smaller (1” / 2.5cm) than the actual size of the table for a tighter, secure fit.
Once you have selected the right height lock the ratchet in place by sliding the lock downwards.
Place the tablet in landscape mode by pulling the spring mechanism upwards and release it to secure the tablet in place. You can adjust the top clamp brackets, if needed, to avoid pressing on any buttons.
Documents / Resources
 |
LifThor Phantom 4 Tripltek Mount [pdf] User Manual Phantom 4, Tripltek Mount |
