Ledbe SP103E LED Magic Controller
Overview
The SP103E is a compact, high-stability controller for addressable RGB pixels, designed for dynamic lighting with an intuitive 14-key RF remote and a wide 5–24V input range.
Specifications
| Input Voltage | DC 5–24V |
| Pixel Capability | Up to 2048 pixels |
| Supported ICs | WS2811, WS2812B |
| RF Remote Range | ~20 meters (~65 feet) |
| Working Temperature | -20°C to 60°C |
| Controller Dimensions | 70 × 12 × 3 mm |
| Remote Dimensions | 85 × 40 × 6 mm |
| Built-in Dynamic Effects | 358 |
| Remote Keys | 14-key RF remote |
| LED Signal Type | TTL/SPI signal addressable RGB pixels |
| Compatibility Note | Not designed for constant voltage PWM LEDs |
Quick Setup & Use
- Provide DC 5–24V input power to the controller.
- Connect supported addressable RGB pixels that use TTL/SPI signaling (WS2811 or WS2812B).
- Use the included 14-key RF remote to select lighting modes and effects.
- Operate within the remote’s range of approximately 20 meters.
- Ensure installation conditions are within -20°C to 60°C and that the total pixel count does not exceed 2048 pixels.
Key Features & Description
- Addressable LED Compatibility: Supports TTL/SPI signal addressable RGB pixels (WS2811, WS2812B).
- Incompatible Devices: NOT designed for constant voltage PWM LEDs.
- RF Remote Control: Includes a 14-key RF wireless remote with approximately 20 meters of range.
- Dynamic Effects: Loaded with 358 built-in dynamic lighting effects.
- Control Capacity: Capable of driving up to 2048 pixels.
- Compact Hardware: Small, high-stability design optimized for space-restricted installations.
Includes
- 1 * SP103E Mini Programmable LED Controller
- 1 * 14Keys RF Remote
- 1 * User Manual
Troubleshooting
- No/incorrect lighting effects: Confirm you are using addressable RGB pixels that match the supported ICs (WS2811, WS2812B) and use TTL/SPI signaling.
- Controller not responding to the remote: Check that you are within the RF remote range (approximately 20 meters).
- Effects are unstable or not working as expected: Verify the input voltage is DC 5–24V and that the operating temperature is within -20°C to 60°C.
- Pixels not lighting fully: Ensure the total number of pixels does not exceed the controller’s capacity (up to 2048 pixels).
- Using wrong LED type: The controller is not designed for constant voltage PWM LEDs; switch to compatible addressable pixels.
Documents / Resources
 | SP103E LED Magic Controller |
References
- User Manualmanual.tools
Published: July 16, 2026