Theben SYN 161 h Analog Clock Timer User Manual
MOUNTING INSTRUCTIONS
Safety information: Electrical devices should only be connected and mounted by an electrical specialist. Manipulations and modifications on the switch will result in a loss of warranty. The national specifications and applicable safety regulations must be observed.
Synchron
- 230 V / 50 Hz
- Quartz * R = 3d (72h) LiMh
- 230 V / 45 – 60 Hz
The quartz movement starts automatically after a few minutes by an applied voltage.
The full power reserve is built up after about 3 days.
24 h Programm
Manual Control ON/OFF (Override Control) Turn the control axis in the direction of the arrow by one notch
ON or OFF = 
The manual control is automatically annulled by the following counteracting command of the automatic program sequence.
Manual
Permanent ON / OFF
Permanent Control ON/OFF
Set the hand lever ❷ to »perm« = permanent control; turning the control axis ❶ in the direction of the arrow, the required permanent control ON or OFF can now be adjusted. Turning the hand lever to »Auto« = Automatic Control, the permanent control is terminated. The actual switch position is maintained until the next counteracting command of the automatic program sequence is triggered. An immediate correction can be carried out using manual control (override control).
EMV / CEM / EMC / ETY
The time switches are by the European directives 73/23/EEC. (Low-Voltage Directive) and 89/336/EEC (EMCDirective). If the time switches are used together with other devices in an installation, take care that the complete installation
does not cause radio interference.
Service
TIMEGUARD LTD, Victory Park, 400 Edgware Road
London NW2 6ND
Tel. 0181/4508944
Fax: 0181/4525143
Download PDF: Theben SYN 161 h Analog Clock Timer User Manual