R1-1 One-key RF Remote Controller
User Manual
One-key portable dimmer/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix
Features
- Apply to single color LED controller.
- Each remote can match one or more receiver.
- CR2032 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on any metal surfaces.
Technical Parameters
| Output signal | RF(2.4GHz) |
| Working voltage | 3VDC(CR2032) |
| Working current | ＜5mA |
| Standby current | ＜2μA |
| Standby time | 2 years |
| Remote distance | 30m(Barrier-free space) |
Safety and EMC
| EMC standard (EMC) | ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4 |
| Safety standard(LVD) | EN 62368-1:2020+A11:2020 |
| Radio Equipment(RED) | ETSI EN 300 328 V2.2.2 |
| Certification | CE,EMC,LVD,RED |
Environment
| Operation temperature | Ta: -30 OC ~ +55 OC |
| IP rating | IP20 |
Warranty
Warranty: 5 years
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
Option 1: stuck on any metal surfaces directly.
Option 2: fix it on the wall with two screws.
Option 3: adhere it to the wall with paster.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key on the remote. The LED indicator fast flash a few times means match is successful.
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times
means all matched remotes were deleted.
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key 3 times on the remote. The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery. - If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling.
- For indoor and dry location use only.
Documents / Resources
 |
SKYDANCE R1-1 One-key RF Remote Controller [pdf] User Manual R1-1, One-key RF Remote Controller, R1-1 One-key RF Remote Controller |
