SCHRADER ELECTRONICS ETMS02 Tyre Pressure Monitoring Sensor
Product Specifications:
- Manufacturer: Schrader Electronics Ltd
- Model: ETMS02
- Type: Tyre Pressure Monitoring Sensor
- Installation: On the tyre of a vehicle
- Communication: RF transmission to receiver inside the vehicle
- Functions: Pressure measurement, battery condition monitoring
Product Usage Instructions
Installation:
- Locate the tyre where you want to install the ETMS02 sensor.
- Securely attach the sensor to the tyre according to the provided installation instructions.
Operation
- The sensor will periodically measure the tyre pressure.
- It will transmit this information via RF communication to the receiver inside the vehicle.
- Monitor the tyre pressure readings on the receiver display.
Battery Condition Monitoring
- The TPMS product also monitors the battery condition of the sensor.
- Replace the sensor’s battery as needed following the manufacturer’s guidelines.
ETMS02 User Manual
The ETMS02 is a Tyre Pressure Monitoring Sensor which is installed on the tyre of a vehicle.
The product measures periodically the pressure of the tyre and it transmits this information by RF communication to a receiver inside the vehicle. In addition, this TPMS product performs the following functions:
- Determines a temperature compensated pressure value.
- Determines any abnormal pressure variations.
- Monitors the state of the product internal battery and informs the receiver of a low battery condition.
System block diagram
Certification information
- FCC ID: MRXETMS02
- IC: 2546A-ETMS02
This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of Industry Canada.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Exposure to radio frequency energy. The radiated output power of this device meets the limits of FCC/ISED Canada radio frequency exposure limits. This device should be operated with a minimum separation distance of 20 cm (8 inches) between the equipment and a person’s body.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm from any body part of nearby persons. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
WARNING: Changes or modifications not expressively approved by the party responsible for compliance could void the user’s authority to operate the equipment. The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.
Frequently Asked Questions
- Q: How do I know if the sensor battery needs replacement?
A: The receiver inside the vehicle will typically display a low battery warning when the sensor battery needs replacement. Refer to the user manual for specific instructions on replacing the battery. - Q: Can the ETMS02 sensor be used on different types of vehicles?
A: The ETMS02 sensor is designed for use on various vehicles, but it’s important to ensure compatibility with your specific vehicle model. Consult the manufacturer or a professional for guidance if needed.
Documents / Resources
 |
SCHRADER ELECTRONICS ETMS02 Tyre Pressure Monitoring Sensor [pdf] User Manual MRXETMS02, ETMS02 Tyre Pressure Monitoring Sensor, ETMS02, Tyre Pressure Monitoring Sensor, Pressure Monitoring Sensor, Monitoring Sensor, Sensor |