RF433M15 Remote Control WiFi Connection Network Logic
“
Product Information
Specifications:
- FCC Compliance: Part 15
- RF Exposure: General RF exposure compliant
- IC Compliance: Licence-exempt transmitter(s)/receiver(s)
Product Usage Instructions
FCC Statement:
When using this equipment, make sure to connect it to a power
outlet on a different circuit than the one the receiver is
connected to. For any assistance, consult the dealer or an
experienced radio/TV technician. Note that any changes or
modifications not approved by the responsible party may void the
user’s authority to operate the equipment.
RF Exposure Statement:
This device meets the general RF exposure requirements and can
be used in portable exposure conditions without restrictions.
IC Statement:
This device contains licence-exempt transmitter(s)/receiver(s)
complying with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). It should not cause interference
and must accept any interference, including that which may cause
undesired operation.
FAQ
Q: What should I do if the device is causing interference?
A: If you experience interference issues, try relocating the
device to a different area. Ensure it is not placed near other
electronic devices that may be causing the interference.
Q: Can I modify the device in any way?
A: No, any changes or modifications not approved by the
responsible party may void your authority to operate the equipment.
Consult a professional if modifications are necessary.
“`
User manual
FCC Statement
Class Bdevice: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Relevés des appareils portables L’appareil a été évalué pour répondre aux exigences générales en matière d’exposition aux RF. L’appareil peut être utilisé en condition d’exposition portable sans restriction.
Documents / Resources
 |
NINGBO RF433M15 Remote Control WiFi Connection Network Logic [pdf] User Manual 2BAT7RF433M15, rf433m15, RF433M15 Remote Control WiFi Connection Network Logic, RF433M15, Remote Control WiFi Connection Network Logic, WiFi Connection Network Logic, Network Logic, Logic |