lumenradio logoINSTALLATION GUIDE
Connect your building automation
system with wireless BACnet

W-BACnet building automation system with wireless

lumenradio W-BACnet building automation system with wirelesslumenradio W-BACnet building automation system with wireless - cablesFor installation, no BACnet cables are needed.

lumenradio W-BACnet building automation system with wireless - mountYou need this for installation. Choose either W-BACnet DIN rail or W-BACnet wall mount.lumenradio W-BACnet building automation system with wireless - mount 1The LumenRadio device next to the BACnet controller (router) can serve as your gateway, with both DIN rail and wall mount options available.

GATEWAY SET-UP

A. DIN rail

lumenradio W-BACnet building automation system with wireless - GATEWAY SET-UP

1 2 3 4 5
9600 baud OFF OFF
19200 baud OFF ON
38400 baud ON OFF
76800 baud ON ON
No parity OFF
Even parity ON
1 stop bit OFF
2 stop bit ON
Use local serial configuration set on Node ON
Use Gateway serial confiauration on Node OFF

lumenradio W-BACnet building automation system with wireless - GATEWAY SET UP 1B. wall mount

lumenradio W-BACnet building automation system with wireless - wall mountSet your Baud rate, stop bit and parity on the gateway (A or B).lumenradio W-BACnet building automation system with wireless - wall mount 1A – Move the switch to ”COMM” or B – Move the switch to ” lumenradio W-BACnet building automation system with wireless - Symbol ”.
Continue by installing the LumenRadio node next to your field devices, starting with the one closest to your gateway.
Ex. Node to room controllerlumenradio W-BACnet building automation system with wireless - startingConnect the LumenRadio device with chosen device (zone controller). Optionally, set a local Baud rate.

lumenradio W-BACnet building automation system with wireless - controllerPlace the LumenRadio device preferably above the chosen device (room controller) and connect. Optionally, set a local Baud rate.lumenradio W-BACnet building automation system with wireless - chosen

The lights on your node will now sweep in blue.lumenradio W-BACnet building automation system with wireless - DIN rail 4 When the lights start blinking green, the node has found the gateway. This can take up to five minutes. lumenradio W-BACnet building automation system with wireless - chosen 1Go back to the gateway.lumenradio W-BACnet building automation system with wireless - chosen 2A – Move the switch to ”GATEWAY” or B – Move the switch to ” lumenradio W-BACnet building automation system with wireless - Symbollumenradio W-BACnet building automation system with wireless - DIN railThe devices blink yellow entering secure mode.
This may take up to 5 minutes.lumenradio W-BACnet building automation system with wireless - DIN rail 1Now you have a wireless connection!lumenradio W-BACnet building automation system with wireless - DIN rail 2To use the W-BACnet app, press the button on the gateway three times so that it blinks blue twice and you are ready to connect.lumenradio W-BACnet building automation system with wireless - DIN rail 3Verify your installation in the app.
For a detailed overview, select Network Map.

lumenradio logoLearn more at www.lumenradio.com

Documents / Resources

lumenradio W-BACnet building automation system with wireless [pdf] Installation Guide
W-BACnet building automation system with wireless, W-BACnet, building automation system with wireless, automation system with wireless, system with wireless, with wireless

References

Leave a comment

Your email address will not be published. Required fields are marked *