LOGICO2 0496 Sniffer Modbus Add-on KIT
TECHNICAL SPECIFICATIONS
- Power supply: 24V DC, from the alarm system
- LED Indications: See table on page 2
- Ambient temperature: 0 to +40°C (+32°F to +102°F) Cable length: 2 x 5 m
- Dimensions (LxWxD): 90 x 161 x 38 mm / 3.5” x 6.3” x 1.5”
FUNCTION
The LogiCO2 Sniffer Modbus is a gateway for reading out measuring values and status (e.g. Alarms) from LogiCO2´s CO2 Safety Systems. It is only possible to read-out information from the Sniffer (read only). The Sniffer Modbus is connected to maximum eight sensors with or without a central unit. The Sniffer is monitoring the communication between the sensor/s and the central unit. If no central unit is installed in the Safety System, the Sniffer Modbus can communicate directly with the Sensor/s. The Sniffer Modbus is intended as a gateway from the LogiCO2 Safety System. The Sniffer Modbus communicates as a slave via Modbus RTU (RS485) to external systems.
The Sniffer Modbus is power supplied from the LogiCO2 Safety System. Default setting is to read-out one Sensor (ID number 1) that is connected to a Central Unit.
INSTALLATION
Connect the cable marked “Connect to sensor” to one of the LogiCO2 Safety System´s red cables.
Use the cable marked “Connect to external system” to connect the gateway RS485 to the external system.
| ORDERING EXAMPLE | |
| Item code |
Description |
| 0496 | Sniffer Modbus with two cables |
Setup – with or without Central Unit
The default setting of the Sniffer Modbus is to communicate with a Safety System together with a Central Unit. To change setting, remove the cover to access the two DIP-switches. For mor information, see the user manual.
LED INDICATION
|
LED |
Colour |
Information |
|
1 |
Yellow |
Lost communication with sensors |
|
2 |
Green |
Flashing when communicating with sensors |
|
3 |
Green |
Power, flashing when communicating with external system |
MAINTANENCE
The LogiCO2-Sniffer requires no maintenance.
CUSTOMER SUPPORT
LogiCO2 International AB
Sweden
info@logico2.com
www.logico2.com
Documents / Resources
 |
LOGICO2 0496 Sniffer Modbus Add-on KIT [pdf] Installation Guide 0496 Sniffer Modbus Add-on KIT, 0496, Sniffer Modbus Add-on KIT, Modbus Add-on KIT, KIT |
