LANCOM Systems GS-3528X Multi Gigabit Ethernet Access Switch
Installation Steps
Configuration interface (Console)
- Connect the configuration interface via the included serial configuration cable to the serial interface of the device you want to use for configuring / monitoring the switch.
TP Ethernet interfaces
- Use Ethernet cables to connect the interfaces 1 to 24 to your PC or a LAN switch.
SFP+ interfaces
- Insert suitable LANCOM SFP modules into the SFP+ interfaces 25 to 28. Choose cables which are compatible with the SFP modules and connect them as described in the module’s documentation.
Power connector (device back side)
- Supply power to the device via the power connector. Please use the IEC power cable supplied or a country-specific LANCOM Power Cord.
Please observe the following when setting up the device
- The mains plug of the device must be freely accessible.
- For devices to be operated on the desktop, please attach the adhesive rubber footpads.
- Do not rest any objects on top of the device and do not stack multiple devices.
- Keep the ventilation slots on the side of the device clear of obstruction.
- Mount the device into a 19” unit in a server cabinet using the provided screws and mounting brackets
Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed installation guide! Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times
| a System | |
| System: off | Device switched off |
| System: green | Device operational |
| System: red | Hardware error |
| b Reset button | |
| ~5 sec. pressed | Device restart |
| 7~12 sec. pressed | Configuration reset and device restart |
| c TP Ethernet por | ts 10M / 100M / 1G |
| LEDs switched to Link/Act/Speed mode | |
| Off | Port inactive or disabled |
| Green | Link 1000 Mbps |
| Green, blinking | Data transfer, link 1000 Mbps |
| Orange | Link < 1000 Mbps |
| Orange, blinking | Data transfer, link < 1000 Mbps |
| LEDs switched to PoE mode | |
| Off | Port inactive or disabled |
| Green | Port enabled, power supply to connected device |
| Orange | Hardware error |
| d TP Ethernet po | rts 100M / 1G / 2.5G |
| LEDs switched to Link/Act/Speed mode | |
| Off | Port inactive or disabled |
| Green | Link 2500 Mbps |
| Green, blinking | Data transfer, link 2500 Mbps |
| Orange | Link < 2500 Mbps |
| Orange, blinking | Data transfer, link < 2500 Mbps |
| LEDs switched to PoE mode | |
| Off | Port inactive or disabled |
| Green | Port enabled, power supply to connected device |
| Orange | Hardware error |
| e 10 G SFP+ port | s |
| Off | Port inactive |
| Blue | Link 10 Gbps |
| Green | Link 1000 Mbps |
| Hardware | |
| Power supply | Internal power supply unit (110–230 V, 50–60 Hz) |
| Power consumption | max. 50 watts |
| Environment | Temperature range 0–40°C; short-term temperature range 0–50°C; humidity 10–90%; non-condensing |
| Housing | Robust metal housing, 19“ 1U (442 x 44 x 375 mm > W x H x D) with removable mounting
brackets, network connectors on the front |
| Number of fans | 1 |
| Interfaces | |
| ETH | A 12 TP Ethernet ports 10 / 100 / 1000 Mbps
A 12 TP Ethernet ports 10 / 100 / 2500 Mbps A 4 SFP/SFP+ ports 1 / 10 Gbps A 28 concurrent Ethernet ports in total |
| Declaration of Conformity | |
| Hereby, LANCOM Systems GmbH | Adenauerstrasse 20/B2 | D-52146 Wuerselen, declares that this device is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, and Regulation (EC) No. 1907/2006. The full text of the EU Declaration of Conformity is available at the following Internet address: www.lancom-systems.com/doc | |
| Package Content | |
| Documentation | Quick Reference Guide (DE/EN), Installation Guide (DE/EN) |
| Mounting brackets | Two 19” brackets for rackmounting |
| Cable | 1 IEC power cord, 1 serial configuration cable 1.5 m |
Documents / Resources
 |
LANCOM Systems GS-3528X Multi Gigabit Ethernet Access Switch [pdf] User Guide GS-3528X, Multi Gigabit Ethernet Access Switch, Gigabit Ethernet Access Switch, Ethernet Access Switch, Access Switch, GS-3528X, Switch |
