iGAGING 400-D68 Depth Indicator Set Instructions

INSTRUCTION
Item# 400-D68

Contents hide

400-D68 Depth Indicator Set

**Please read through this instruction carefully before using the tool. Use the tool for its intended purpose only.
Item# 400-D68 : 0-22” Depth Indicator Set

Parts:

Two-Threaded Positions Depth Base
Connector (installed on indicator)

Dial Indicator (item# 400-005)
Bezel Locking Screw

Depth Rods: 1,2,3,4,5,6”
Measuring points: (flat, needle, ball, spline)

Full set with protective case

Specifications
Indicator range: 0-1” Depth gauge range: 0-22”
Indicator resolution: 0.0005”
Indicator accuracy: ±0.0005”
Indicator repeatability: 0.0005”
Indicator tolerance: ±0.001”

Operations
Zero setting: 1. Loosen the indicator bezel lock.
Secure the indictor on base with flat or ball points (without any rod attachment); push down the indicator against a flat surface and make sure base is tightly against the surface; adjust the dial on the indicator to the “0” position and tighten the screw.
2. For using needle and spline points: zero setting the indicator using an setting master.
Depth base: 2-position base for easy position exchange.
Connector: screw and un-screw to change position of the indicator on the base.
Depth rods: 1” to 6” rods can add up to 22” in range.
Measuring tips: 4 different measuring tips to use in different applications.

Zero setting with ball contact and without extension on a flat surfaceZero setting when using extension rod and/or flat, needle, or spline point and with a pair of block, and on a flat surface.