GO IN STYLE DAF LED Daytime Running Lights Installation Guide
INSTRUCTIONS SWITCHABLE DRL DAF
- Start with disassemble your headlights and the 2 units on the back.
- Replace the original DRL with the new ones with the thermal paste.
- The original connector is going to new switch board.
- And the flat cable to the DRL unit.
- Be sure you mount the flat cable in the right way!
- Make an 8mm hole to fit the connector to the outside of the headlight make sure the inside of the headlight is a flat surface.
- The 4m wire is going to the 106 switch.
- The blue cable is ground.
- The black cable is the switch wire.
- After that, you can put everything back together.
Notice: Plugs can only be installed this way.
Documents / Resources
 |
GO IN STYLE DAF LED Daytime Running Lights [pdf] Installation Guide DAF LED Daytime Running Lights, DAF, LED Daytime Running Lights, Daytime Running Lights, Running Lights, Lights |
