Contents
hide
ESBE CRA122 Series Setpoint Temperature Controller
Specification
- Ambient temp: 23°F to 131°F (-5°C to 55°C)
- Flow temp. range: 4°F to 200°F (5°C to 95°C)
- Power supply: 24 ± 10%, 60 Hz
- Power consumption: 3VA
- Max run time at max speed: 120 seconds
- Weight: 2 lbs (0,9 kg)
CRA122 Package Contents
Assembly Orientation
Temperature Sensor Installation
Wiring
Selection Buttons
Factory Reset
Setting Rotation Time
| 24VAC | |
| *at 50Hz | at 60Hz |
| 15 sec | 12 sec |
| 30 sec | 25 sec |
| 60 sec | 50 sec |
| 120 sec | 100 sec |
| 240 sec | 200 sec |
| 480 sec | 398 sec |
Maximum Temperature Limitation
Changing of Setpoint
°F / °C Temperature Unit Display
T2, Secondary Temperature Setpoint
Actuator Rotation Adjustment
if actuator rotation requires more than or less than 90° actuator rotation
Distributed by Danfoss in North America
Frequently Asked Questions
- Q: How do I reset the controller to factory settings?
- A: To perform a factory reset, press and hold the reset button for a few seconds until the device resets.
- Q: What is the power source requirement for the CRA122?
- A: The CRA122 requires a power source of 24 VAC for operation.
- Q: How do I install the temperature sensors?
- A: Wrap the temperature sensor properly and follow the installation instructions provided in the manual for accurate installation.
Documents / Resources
 |
ESBE CRA122 Series Setpoint Temperature Controller [pdf] Instruction Manual CRA122, CRA100, CRB100, CRA122 Series Setpoint Temperature Controller, CRA122 Series, Setpoint Temperature Controller, Temperature Controller |