io HSP HFCL 24Port PoE Plus L2 Managed Switch User Guide
Also Applicable on:
HSP-IO-24GE4XS-C1A
24-Port, Non PoE, L2 Managed Switch,
4×1/10G SFP+ Uplinks, Single AC Power Supply
Introduction
Thank you for choosing 24-port managed Switch from HFCL Switching Platform (C1 Series).PoE Variants Suitable in an enterprise/telco/campus environment to connect end PoE clients like Wi-Fi AP, CCTV, P2P, P2MP, IoT etc.Non-PoE Variants Suitable to connect Small Cells/BTS, P2P/P2MP etc. in telco environment and Desktops/Servers, IP-Phone etc. in an Enterprise/Campus environment.
Front View:
Packaging Content
- 24 Port Switch Qty: 1 number
- Mounting clamps with screws
- Power Supply cable: 1 Pc
Installation:
Assembly of brackets for Rack mounting described in below diagram for 24 Port L2 managed Switch Model.
Step 1. Attach the mounting brackets to both sides of the chassis. Insert screws and tighten then with a screwdriver to secure the brackets.
Step 2. Place the switch on a rack shelf in the rack. Push it in until the oval holes in the brackets align with the mounting holes in the rack posts.
Step 3. Attach the brackets to the posts. Insert screws and tighten them.
Login Access
Access Via Web-GUI:
Steps:
- Connect your PC to the Switch and ensure its IP address is in the same subnet, default IP of Switch is 192.168.0.239/24
- Open the web browser and enter the URL:
http://192.168.0.239 to access the Switch’s local web GUI. - Use the default login credentials (Username is “admin” and Password is “password”) to log in to the Switch’s local web page.
If your PC is configured correctly, you should see the login page of the Switch as shown by Image:
Access Via Console:
The console access to the Switch can be obtained via the RJ45 console port. An administrator can access device using command line interface (CLI) with following console port setting as part of factory default configuration.
Speed: 115200 bps | Data bits: 8 | Stop bit: 1
Parity: None | Flow control: Hardware
Product Specification
24 Port L3 Managed Switch Specifications
LED Description
Reset to default: Press and hold for over 10 seconds, and all ports LED will go off and on. Then the device will be reset to factory default settings.
Change LED display mode: Press the button to change the LED mode to display the PoE status of PoE-enabled ports.
Safety Precautions
Observe the following safety precautions to avoid damage to the Switch:
Do not power the device during installation.
Keep away from high voltage cables.
Do not power off the unit in the middle of an upgrade process.
Do not open the enclosure.
Disclaimer : Images are for representation, final product may differ.
iosupport@hfcl.com
hfcl.com | io.hfcl.com
HFCL Limited All Rights Reserved. HFCL and io by HFCL are trademarks or registered trademarks of HFCL Ltd. Specifications are subject to change without notice.
Documents / Resources
 |
io HSP HFCL 24Port PoE Plus L2 Managed Switch [pdf] User Guide HSP-IO-24GE4XS-C1PA, HSP-IO-24GE4XS-C1A, HSP HFCL 24Port PoE Plus L2 Managed Switch, HSP, HFCL 24Port PoE Plus L2 Managed Switch, PoE Plus L2 Managed Switch, L2 Managed Switch, Managed Switch |