LAB-T 700841-001 27 MHz and 433 MHz RF Remote User Manual

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - front page
Copyright ⓒ 2024 Lab-T, Inc.

TouchTunes HRC540A 27 MHz and 433 MHz RF Remote
Document Number: MAN901214-001

About This Guide

Purpose

This guide explains the setup and operation of the TouchTunes 27 MHz frequency wireless remote control, P/N 700842-001 (which should be ordered as P/N 600330-001) and the 433 MHz frequency wireless remote control, P/N 700841-001 (which should be ordered as P/N 600329-001).

Package Contents
  • Remote control;
  • Two (2) AAA alkaline batteries;
  • This guide (901214-001).
Overview

The TouchTunes single-frequency wireless remote control has integrated flash memory to help prevent it from losing its ID when the batteries drain.

It is RF-based, which eliminates the need to point it directly at the jukebox and is powered by two (2) 1.5V AAA batteries (included with the remote).

The black remote transmits a 27 MHz signal [ Figure 1 – 27 MHz Remote (Black) ]

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - MHz Remote
Figure 1 27 MHz Remote (Black)

And the blue remote transmits a 433Mhz [ Figure 2 – 433 MHz Remote (Blue) ]

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - 433 MHz Remote
Figure 2 433 MHz Remote (Blue)

Installing the Batteries

  1. Using a cross-head screwdriver, remove the battery cover plate;
  2. Install the batteries in the remote;
    LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Installing the Batteries
  3. Close the battery cover plate and fasten the screw.

Setting the Remote Control ID

  1. Press and hold the POWER and F4 keys at the same time for approximately five (5) seconds. The remote will switch into a state where it is ready to set a new Control ID and the indicator LED lights up and stays on.
    LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Setting the Remote Control ID
  2. Press one of the 28 keys corresponding to the HEX code desired to select a unique Control ID (refer to section [4] – Remote Functions).
    The remote is now ready to be synced to the jukebox.

Remote Functions

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Remote Functions
NOTE: Jukes using Gen3 cannot use Control-ID 000.

NOTE: The QR Code on the remote enables quick access to the online Quick Refence Guide (QRG).

Learning the Remote ID

On the Operator Menu, open the Hardware Options screen.

  1. Press the LEARN button.
    LAB-T 700841-001 27 MHz and 433 MHz RF Remote - LEARN button
  2. Watch the display. When prompted, press the MIC VOL UP key on the remote control.
    LAB-T 700841-001 27 MHz and 433 MHz RF Remote - press the MIC VOL UP key on the remote control
    The display will show a success message and return to the Options screen.
  3. Test the remote by raising and lowering the jukebox volume as it is playing.

Key Assignments and Functionality

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Key Assignments and Functionality
LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Key Assignments and Functionality
LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Key Assignments and Functionality
LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Key Assignments and Functionality
LAB-T 700841-001 27 MHz and 433 MHz RF Remote - Key Assignments and Functionality

NOTE: Only the volumes of activated zones can be controlled; volume buttons for zones that are not activated will have no effect

Safety Notices

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - caution icon CAUTION: Do not use or store the remote near any heat sources, such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

LAB-T 700841-001 27 MHz and 433 MHz RF Remote - caution icon CAUTION: Dispose of used batteries in accordance with the regulations in your area. Do not incinerate.

FCC/IC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.

FCC Caution

Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

* This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

Contacting TouchTunes Support

If you require assistance with this or any other TouchTunes product, please call TouchTunes Tech Support at 888-338-5853 or email us through Tempo > Help > Contact Us > Technical. We value your comments!

To help us assist you more effectively with problem reports, the following information may be required when contacting TouchTunes:

  • Jukebox model and ID
  • Operator ID
  • Serial number or part number of the component you believe to be defective
  • Date/time of the problem
  • Actions performed immediately before the problem occurred
  • Any additional comments relevant to the problem

7250 Mile End, Suite 202 Montreal, Quebec, Canada, H2R 3A4

730 Third Ave 21st Floor New York, NY 10017

Technical Support
888-338-5853
www.touchtunes.com

Documents / Resources

LAB-T 700841-001 27 MHz and 433 MHz RF Remote [pdf] User Manual
700841-001 27 MHz and 433 MHz RF Remote, 700841-001, 27 MHz and 433 MHz RF Remote, 433 MHz RF Remote, RF Remote, Remote

References

Leave a comment

Your email address will not be published. Required fields are marked *