Shopify Material Testing Software

Shopify Material Testing Software

Material testing

  1. If you need to test the engravi nq result of the material, you can quickly test the material through the material tesl: function.
    Step 1: Click “Test” button on the menu on the right side of workspace.
    Step 2: Set the required test parameters in the list.
    Step 3: Set the title text engraving parameters in the material testing mat rix.
    Step 4: Frame to check whether the engraving area is proper, and click “Start” button to start engraving.
    Material testing
    1. Parameter. Set the engraving parameters that need to be tested.
    2. Rows: Set the number of “rows” in the test array.
    3. Columns: Set the number of “columns” in the test array.
    4. Min: test the minimum value of engraving parameters.
    5. Max: Test the maximum value of the engraving parameters.
    6. Height: Set the height of each engraved rectangular object in the test array.
    7. Width: Set the width of each engraved rectangular object in the test array.

Documents / Resources

Shopify Material Testing Software [pdf] User Guide
Material Testing Software, Material Testing Software, Testing Software, Software

References

Leave a comment

Your email address will not be published. Required fields are marked *