Raspberry Pi Pico-CAN-A CAN Bus Module

Raspberry Pi Pico Header Compatibility:

Onboard Female Pin Header for Direct Attaching to Raspberry Pi Pico Raspberry Pi Pico is NOT included.

What’s on Board:

1. E810-TTL-CAN01 module
2. Module operating indicator
3. Module status indicator: operating mode: blinking at 1Hz frequency
   command configuration mode: blinking at 5Hz frequency
4. TX/RX indicators
5. Resistor config: ON: connected to 120R matching resistor
   OFF: disconnected from 120R matching resistor (default)
6. CAN bus terminal
7. Power supply selection
8. UART selection

Pinout Definition:

Documents / Resources

Raspberry Pi Pico-CAN-A CAN Bus Module [pdf] User Manual Pico-CAN-A CAN Bus Module, Pico-CAN-A, CAN Bus Module, Bus Module, Module

References

• User Manual