QwikProducts QT6104 Variable Speed Motor Replacement Installation Guide
Determine Motor Voltage
Jumper Wire – Use 120 VAC replacement PSC motor and capacitor
No Jumper Wire – Use 240 VAC replacement PSC motor and capacitor
Connect the QwikSwap V3
With power off, remove the 5-pin power and 4-pin signal connectors from defective ECM motor and plug them into mating connections on the QwikSwap V3 board
5-pin Connector from Motor to
QwikSwap V3 Board
then… With power off, remove the 16-pin signal connector (with more than 4 wires) from defective ECM motor and plug it into mating connection on the QwikSwap V3 board
4-pin Connector from Motor to Qwik Swap V3 Board
16-pin/4 wire Connector from Motor to QwikSwap V3 Board
More than 4 wires on this 16-pin connector? Use the other instructions!
IF THE PLUGS DON’T FIT YOU’RE USING THE WRONG QWIKSWAP, NEVER CUT THE CONNECTORS OFF!
Flip over to the back of this sheet, there’s a few more steps
Select the Horsepower
Use the Configuration Switches on the Board to select the horsepower of the defective ECM motor.
Note the direction of ON/OFF in the Figure.
NOTE: OFF position is indicated by a down arrow at the left of the set!
| CONFIGURATIONSWITCHNPOSITION | ||||||||
| H.P. | 1 | 2 3 | 4 | OFF | 6 | 7 | 8 | |
| 1/8 | ON | OFF OFF | OFF | OFF | OFF | OFF | OFF | |
| 1/4 | ON | ON OFF | OFF | OFF | OFF | OFF | OFF | |
| 1/3 | ON | ON ON | OFF | OFF | OFF | OFF | OFF | |
| 1/2 | ON | ON ON | ON | ON | OFF | OFF | OFF | |
| 2/3 | ON | ON ON | ON | ON | OFF | OFF | OFF | |
| 3/4 | ON | ON ON | ON | ON | ON | OFF | OFF | |
| 1 | ON | ON | ON | ON | ON | ON | ON | |
In this figure the motor has been set to 1/3 hp:
(ON, ON, ON,
OFF, OFF, OFF, OFF, OFF)
Verify Proper Operation & Lock in Settings
Reconnect power to the air handler. A flashing Yellow status LED and solid Red (COM) LED indicate proper communication
A If the Yellow LED is off, verify power to the QwikSwap V3 board. If the RED LED is off or flashing, there is a communication error.
b Lock in the Configuration. With power still being supplied to the QwikSwap V3 board, set all configuration switches to OFF.
C Set the Fan to On. Following a short delay, the Green (HIGH) LED should initially light and then settle on one of the (HIGH), (MED) or (LOW) LEDs.
d Set the Fan to Off. Following a short delay, all the Green LEDs should turn off.
Install the Replacement PSC Motor & Capacitor (same rotation and voltage)
a Install the replacement PSC motor, mount the QwikSwap V3 board and run capacitor.
b Connect the PSC motor common wire to the MOTOR COM terminal on the QwikSwap V3 board.
c Connect the three PSC motor speed taps to the corresponding terminals on the QwikSwap V3 board
Documents / Resources
 |
QwikProducts QT6104 Variable Speed Motor Replacement [pdf] Installation Guide QT6104 Variable Speed Motor Replacement, QT6104, Variable Speed Motor Replacement, Speed Motor Replacement, Motor Replacement, Replacement |
