Generic MT6701 Magnetic Encoder Magnetic Induction Angle Measurement Sensor Module User Manual

MT6701 Magnetic Encoder Magnetic Induction Angle Measurement Sensor Module

Product Information

Specifications:

  • Model: MT6701 Module
  • Supply Voltage: 3.3V to 5V

Product Usage Instructions

1. Power Supply:

Ensure that the supply voltage provided to the MT6701 Module is
within the range of 3.3V to 5V.

2. Connection:

Connect the MT6701 Module to your device following the specified
pin configurations in the user manual.

3. Operation:

After ensuring proper power supply and connection, you can start
operating the MT6701 Module as per your application
requirements.

4. Troubleshooting:

If you encounter any issues during operation, refer to the
troubleshooting section of the user manual or contact customer
support for assistance.

FAQ (Frequently Asked Questions)

Q: What is the supported supply voltage for the MT6701
Module?

A: The MT6701 Module supports a supply voltage
range of 3.3V to 5V.

Benutzerhandbuch / User Manual

DEUTSCH
Der MT6701 ist ein 14-bit Magnetfeld Hall Sensor zur Erfassung von · Detection eines Magnetfelds · Messung einer Magnetfeldstärke · Messung von Winkel und Rotation
Der MT6701 ist neuartiger magnetischen Winkelencoder basierend auf dem differentiellen Hall-Induktion Prinzip von MagnTek. Der MT6701 erfasst die Magnetfeldkomponente senkrecht zur Chipoberfläche mit einem radial rotierenden Magneten. Der MT6701 erfasst Winkelsignale von 0~360°. Neben der analogen 12-bit Ausgabe über ABZ/ UVW-Inkrementalausgangs bzw. eines Analog/ PWM Absolutwinkelausgangs bietet der MT6701 auch einen 14-Bit-Digitalwinkelausgang über die I2C/SSI-Schnittstelle. Zusätzlich zur Drehwinkelbestimmung bietet MT6701 auch einen Push / Taster-Ausgang. Das MT6701 Modul unterstützt Spannungsversorgungen von 3,3V bis 5V.

ENGLISH
The MT6701 is a 14-bit magnetic encoder · Detection of the magnet · Get magnetic intensity · Get the Angle and Rotation information
MT6701 is a new generation of magnetic angle encoder chip based on the principle of differential Hall induction launched by MagnTek. MT6701 senses the magnetic field component perpendicular to the surface of the chip, with the rotation of a radial magnet magnetized on the surface of the chip, MT6701 correspondingly outputs an angle signal of 0~360°. In addition to 12-bit providing ABZ/UVW incremental output and Analog/PWM absolute angle output, MT6701 also provides 14 bit digital angle output through I2C/SSI interface. In addition to rotation angle measurement, MT6701 also provides a “press” output to realize singlechip button (rotation + press) function.
The MT6701 Module supports 3.3V up to 5V supply voltage.

Documents / Resources

Generic MT6701 Magnetic Encoder Magnetic Induction Angle Measurement Sensor Module [pdf] User Manual
MT6701, MT6701 Magnetic Encoder Magnetic Induction Angle Measurement Sensor Module, MT6701, Magnetic Encoder Magnetic Induction Angle Measurement Sensor Module, Encoder Magnetic Induction Angle Measurement Sensor Module, Induction Angle Measurement Sensor Module, Measurement Sensor Module, Sensor Module, Module

References

Leave a comment

Your email address will not be published. Required fields are marked *