Firstech FTI-CDP1 Techfeedtree

Specifications

Make	Model	Year	Install	CAN	Lights	IGN	Hood	I/O Changes
DL-CH8					Park / Auto			Green White/Blue
RAM	1500 Classic TIP Start	2019-23	Type 2	JCB	Type B	BCM	BCM

• Firmware: Covered vehicles use either BLADE-AL(DL)-CH8, confirm the application, and flash module, and update the controller firmware before installing.
• Install: Type 2 vehicles use the included CAN extension cable to source CAN data from the green CAN junction block (left side of the dash) or the BCM (pin#25, CANH, brown, pin #26, CANL, yellow).
• Lighting: Type B parking lights use the 10-pin connector, and secure unused 6-pin connector for safety.
• Ignition: Common ignition provisions are listed in the BLADE diagram, ignition is also available at the vehicle BCM (connector C5/E, pin #27, pink/white).

Installation

FTI-CDP1 – Installation and Configuration Notes

• A Required CAN connection.
• B Not required.
• C Hood pin connection (if required).
• D Ignition jumper, NO CONNECTION required.
• E Ignition connection.

BLADE FEATURE COVERAGE

IMMOBILIZER DATA

PRIORITY UNLOCK

DOOR LOCK

DOOR UNLOCK

ARM OEM ALARM

DISARM OEM ALARM

TRUNK/HATCH

DOOR STATUS

TRUNK STATUS

BRAKE STATUS

E-BRAKE STATUS

TACH OUTPUT

DATA/MUX IGN/ST

GLOW PLUG STATUS

SECURE TAKEOVER

PARKING LIGHTS

HAZARD LIGHTS

DISCO BALL

CM900AS/900S Jumper

FTI-CDP1 – DL-CH8 – Type 2 2019-23 RAM 1500 Classic TIP Start

LED Programming Error Codes

Module LED flashing RED during programming

• 1x – CAN Error, check CAN wiring and voltages
• 2x – Key code not learned, confirm unlock sent, check CAN
• 3x – No immobilizer data, check immo data connection
• 4x – No IGN, check IGN connection
• 5x – VIN not found, check CAN connections
• 6x – No immobilizer data, check immo data connection
• 7x – Not the same key, use only one key for programming
• 8x – No immobilizer data, check immo data connection
• 9x – No immobilizer data 10x – Klon error, redo Klon

MODULE PROGRAMMING PROCEDURE

MODULE PROGRAMMING PROCEDURE – WITH KLON

WARNING: READ BEFORE REMOTE STARTING THE VEHICLE

IMPORTANT

1. All vehicle doors must be closed and locked before the remote start sequence. Failure to comply will result in a remote starter malfunction.

TAKE OVER PROCEDURE – TO THE VEHICLE OWNER

NOTE

• All vehicle doors must be closed and locked before the remote start sequence.

1. Press UNLOCK on the after-market remote.
2. TIME RESTRICTION
   • Within 45 SECONDS from the previous step:
     • Open the vehicle door.
     • Enter vehicle.
     • Close the vehicle door.
     • Insert key into the ignition.
     • Turn the key to the ON position.
     • Press and release the BRAKE pedal.
     • Failure to follow the procedure within the time restriction will result in vehicle engine shutdown.

WWW.IDATALINK.COM Automotive Data Solutions Inc. © 2020

Documents / Resources

Firstech FTI-CDP1 Techfeedtree [pdf] Instruction Manual FTI-CDP1, DL-CH8 RAM 1500 Classic Tip Start, FTI-CDP1 Techfeedtree, FTI-CDP1, Techfeedtree

References

• User Manual