Danfoss AK-SM 820 System Manager Instructions

Danfoss AK-SM 820 System Manager Instructions

Contents hide

General mounting

		-10°< tamb < 55°C° 14°F < tamb < 130° F0 – 95% RH, non condensing IP 20


Supply Relay 2	Modbus, Lon-version

US mounting

		Listed UL file: E 31024 61B5 Class 2 or LPS in accordance with NEC. For supply connections, use 16 AWG or larger wires rated for at least 75°C (167°F). Use copper conductress only. 14°F < tam b < 130°F 0 – 95% RH, non condensing IP 20
Panel mounting
Supply Relay 2 For safety reasons both supply voltage and relay voltage must be the same voltage.	Mod bus, Lon-version Mod bus LON
	TP 78-version

The actual installation of the data communication cable must comply with the requirements mentioned in the document “Data communication between ADAP-KOOL® Refrigeration controls”. Literature sheet number = RC8AC.

Termination

Modbus

LON

If a repeater is used, make sure the terminatorsare used (included with repeater).
Use the included 120 Ohm terminator on last device.

Address
Direction

0 = Mater
1 – 9 = Slave

IP
LAN Use shielded ether net cable

Initial settings

Press “Next”
Select language
Set Date / Time
Set Engeneering unit preferences
Set Users / Password
Default: User = Supervisor / Password = 12345
Set Communications
OK and Finish (reset)

Configuration
See manual: USCO.PI.R1.H1.–

The Product contains electrical components And may not be disposed together with domestic waste.
Equipment must be separate collected with Electrical and Electronic waste. According to Local and currently valid legislation.

AK-SM 820/850/880 Instructions RI8PU953 © Danfoss 01/2019 3

Documents / Resources

	Danfoss AK-SM 820 System Manager [pdf] Instructions AK-SM 820 System Manager, AK-SM 820, System Manager, Manager
	Danfoss AK-SM 820 System Manager [pdf] Instructions AK-SM 820, AK-SM 850, AK-SM 880, AK-SM 820 System Manager, AK-SM 820, System Manager, Manager