STUSB1602 Software Library for STM32F446 User Guide
Introduction
This document provides an overview of the STUSB1602 software package enabling USB PD stack with NUCLEO-F446ZE and MB1303 shield
|
SOFTWARE |
|
|
STSW-STUSB012 |
STUSB1602 software library for STM32F446 |
|
IAR 8.x |
C-code compiler |
|
HARDWARE |
|
|
NUCLEO-F446ZE |
STM32 Nucleo-144 development board |
|
P-NUCLEO-USB002 |
STUSB1602 Nucleo Pack containing MB1303 shield (Nucleo expansion board to be plugged on NUCLEO-F446ZE) |
SW library set-up
- Download the STUSB1602 software package by searching STSW-STUSB012 from www.st.com home page:
- Then click on “Get Software” from either the bottom or top of the page
- Download will start after accepting the License Agreement, and filling contact information.
- Save the file en.STSW-STUSB012.zip on your laptop
and unzip:
- The package contains a DOC directory, ready-to-use binary files, associated projects and compliance reports
Suggested Hardware requirements
The software library has been optimized to quickly compile on the NUCLEO-F446FE development board stacked with MB1303 expansion board (from P-NUCLEO-USB002 package).
MB1303 is composed of 2 Dual Role Ports (DRP) USB PD capable receptacles (form factor not optimized)
- NUCLEO-F446ZE
- MB1303
NUCLEO-F446ZE Hardware set-up
Software package Overview
The software library includes 8 different software frameworks (+ 3 without RTOS) already optimized to address most common application scenario:
|
Project |
Typical Application |
|
|
#1 |
STM32F446_MB1303_SRC_ONLY(*) | Provider / SOURCE (power management) |
|
#2 |
STM32F446_MB1303_SRC_VDM | Provider / SOURCE (power management) + extended message support |
|
#3 |
STM32F446_MB1303_SNK_ONLY(*) | Consumer / SINK (power management) |
|
#4 |
STM32F446_MB1303_SNK_VDM | Consumer / SINK (power management) + extended message support + UFP support |
|
#5 |
STM32F446_MB1303_DRP_ONLY (*) | Dual Role Port (power management) + dead battery mode |
|
#6 |
STM32F446_MB1303_DRP_VDM | Dual Role Port (power management) + dead battery mode + extended message support + UFP support |
|
#7 |
STM32F446_MB1303_DRP_2ports | 2 x Dual Role Port (power management) + dead battery mode + extended message support + UFP support |
|
#8 |
STM32F446_MB1303_DRP_SRCING_DEVICE | Dual Role Port requesting PR_swap when attached in Sink or DR_swap when attached in Source |
- by default, all projects are packaged with RTOS support
- project annotated with a (*) are available with and without RTOS support
For more details, please check Firmware Package documentation:
Documents / Resources
 |
ST STUSB1602 Software Library for STM32F446 [pdf] User Guide STUSB1602, Software Library for STM32F446 |
