Kwikboost 8-Bay-10-Bay Multi Device Charging Lockers Instructions
Required Hardware:
8-Bay Lockers
QTY 2 KwikBoost Standard Replacement Cable Bundle:
- USB-C x 8
- Lightning x 8
- Zip ties x 8
10-Bay Locker
QTY 2 KwikBoost Standard Replacement Cable Bundle:
- USB-C x 10
- Lightning x 10
- Zip ties x 10
Required Tools:
Rear Access Panel Door Key (supplied with Locker)
Wire Cutters (or scissors)
Assembly:
- Unplug the Charging Locker from the wall outlet.
- Access the electronics by unlocking and opening the door located on the back of the locker.
TIP: Before proceeding to Step 3, take photos of the cable routing and zip tie placement for future reference.
- Unplug the charging cables from the charging modules.
NOTE: Your charging module may differ slightly in appearance from the example shown in the photo. - Use the wire cutter to remove the zip ties securing the old cables. Then, remove the old cables by sliding them out of the cable holes.
- Plug the replacement cables into the charging modules, secure the cables with zip ties, and then route the cables through the cable holes into the charging lockers.
Need more info?
www.LuxorWorkspaces.com
Documents / Resources
 |
Kwikboost 8-Bay-10-Bay Multi Device Charging Lockers [pdf] Instructions 8-Bay, 10-Bay, 8-Bay-10-Bay Multi Device Charging Lockers, Multi Device Charging Lockers, Device Charging Lockers, Charging Lockers, Lockers |
