KRYPTONITE 815 Key Cable Instruction Manual

KRYPTONITE 815 Key Cable

Product Information

Specifications

• Product Name: 815 Key Cable
• Manufacturer: Kryptonite
• Address: 5 Shawmut Road Canton, MA 02021
• Phone: (781) 828-6655
• Website: www.kryptonitelock.com

BRACKET INSTALLATION

1. Unscrew the screw with a 4mm hex wrech and pull out the strap.
2. Wrap strap around tube and press it slightly in insertion area (A).
3. Tighten the screw with a 4mm hex wrech until the bracket is snug and will not move. Then cut away the excess strap if necessary.
4. Insert the lock like shown in image 3. You will hear a click when the lock has successfully been inserted into the bracket.
5. To remove press down on the release button (B) and slide the lock up.
6. If you would like to mount the lock horizontaily, repeat step 1. Then carefully pull the strap out from the bracket body (C). Once removed, turn (C) 1/4 of a turn so it looks like image 6. Then slide the strap back through the strap port. Follow the same as steps 1 – 4 to mount your bracket on the bike. When completed the cable should look like the example in image 6.

PROPER BICYCLE LOCK UP

• Place the bike against an anchored stationary object. Place the Kryptonite cable around the stationary object and through the bike frame. Remove key.
• Check the lock before leaving the bike to be sure it is properly secured. Whenever possible, capture the anchored stationary object, the frame, and rear wheel within the cable.
• Cable locks are deterrent security only. For additional high-security proper lock-up information, please visit www.kryptonitelock.com.

Tips:

• Always lock a vehicle in a well-lit area with high foot traffic.
• Always lock a vehicle to a solid object that the vehicle cannot be lifted over.
• Make sure the object that the vehicle is locked to cannot be cut.
• Where possible always make sure the vehicle frame and both wheels are secure.
• Lock according to value of the vehicle – frame, back wheel, front wheel.
• Get the tightest fit possible! The less room inside the u-lock or chain the better as it makes it difficult for thieves to use their tools.
• Position the lock off the ground with the keyhole facing down.

KEY SAFE – KEY REGISTRATION AND KEY REPLACEMENT PROGRAM

For as long as the customer owns the Kryptonite lock, if keys are lost and the key number has been registered with Kryptonite, Kryptonite will send the first pair of standard replacement keys for a flat global shipping charge of $6.95 USD.. To register keys, complete the form on Kryptonite’s website: Kryptonitelock.com > Customer Service > Register keys/combination.

CARE & MAINTENANCE

Lubricate the lock several times a year to keep the lock in its best working condition. Always use a lubricant that has only a silicone, graphite or Teflon base. Face the lock cylinder upright and spray or pour the lubricant into the cylinder. Let it sit for 5 minutes. Place a rag on the workstation and turn the lock over onto the rag for a few minutes.
Note: Do not use WD-40! WD-40 is a solvent, not a lubricant and will remove lubricant in the cylinder.

LIGHTED KEY

If the lock comes with a lighted key:

• TO CHANGE THE BATTERIES: Remove both screws and lift off key cover and replace the batteries (two 1.5v lithium batteries (AG10, 389, 189, LR1130 or LR54) with the “+” facing up. Make sure the contact spring is properly fitted into the underside of the button and replace both key cover screws.
• TO REMOVE AND/OR REPLACE THE KEY BLADE FROM THE LED CASE: Turn the LED case over to the backside and unscrew the 2 screws. Hold LED case in one hand, then pull upwards on the key ring of the Key Blade to completely remove.
• TO REINSERT A NEW KEY BLADE INTO THE LED CASE: Slide the Key Blade into the opening of LED case until you hear a click. Be sure the stamp key code area is facing you. Insert the two screws and tighten clockwise.

LIFETIME LIMITED PRODUCT WARRANTY

Schlage Lock Company, LLC, through its Kryptonite division (“Kryptonite”) extends a limited lifetime warranty to the original user of the products manufactured by Kryptonite (the “Products”) against defects in material and workmanship. This warranty only applies to the Original User of Products. This warranty is not transferable. This warranty gives you specific legal rights, and you may also have other rights, which vary from location to location. For complete warranty information and additional terms and conditions please visit Kryptonite’s website at www.kryptonitelock.com or call Kryptonite at 1-800-729-5625 (USA Only) or 001 781-828-6655.
To contact Kryptonite, go to www.kryptonitelock.com or call 1-800-SAY-LOCK (USA Only) or 001 781-828-6655.

FAQ

• Q: Can I use WD-40 for lubricating the lock?
  A: No, WD-40 is not recommended as it is a solvent and will remove lubricant in the cylinder. It is advised to use a lubricant with a silicone, graphite, or Teflon base.
• Q: How do I change the batteries in the lighted key?
  A: Remove both screws from the key cover, lift off the cover, replace with two 1.5v lithium batteries with the + facing up, and ensure proper fitting of the contact spring.