KONA LABS logoMeter Dog Water Monitoring System
User GuideKONA LABS MeterDog Water Monitoring SystemMeter Dog™ Quick Guide

Meter Dog Water Monitoring System

KONA LABS MeterDog Water Monitoring System - MeterDog

  1. Secure the Meter Dog Sensor to the water meter register using the provided cable ties. Be sure the sensor tip is up against the meter register.  KONA LABS MeterDog Water Monitoring System - MeterDog1
  2. Position the antenna as high as possible to optimize cellular signal using the stake. Avoid installing the antenna tip on metal or on the groundKONA LABS MeterDog Water Monitoring System - magnet
  3. To activate the MeterDog, place the magnet as indicated for 30 seconds. Remove the magnet once the LED switches from Red to Orange.KONA LABS MeterDog Water Monitoring System - magnet1
  4. The MeterDog will continue to flash while establishing a secure connection. Activation is successful once the LED goes from solid green, then the LED turns off.

Account Setup

To start seeing data online you will need to register the device and create an account.
Step 1 – Go to: https://customers.konametrix.com/#/selfinstall or scan QR Code.
Step 2: Register the device by using the 6 digit Sensor ID located on the top of the MeterDog. Once registered, you will receive an email to complete setting up your account. Make sure to use an email you have access too. Check the junk folder if you do not see it in your primary folder.
Step 3- Log into the MeterDog Dashboard and set up alerts.
If you need additional support scan the QR code for installation and support videos or send us a email at support@konalabs.com

KONA LABS MeterDog Water Monitoring System - qr code KONA LABS MeterDog Water Monitoring System - qr code1 KONA LABS MeterDog Water Monitoring System - qr code2
https://customers.konametrix.com/#/selfinstall
https://www.youtube.com/playlist?list
=PL6sTEwbRV4fRpGrjY88IIZ_zcM_SvT798
https://www.konametrix.com/login

MeterDog Notes

  • It will take 24 hours after activation to generate a Water Number
  • The LED will turn off once activation is completed.
  • The MeterDog only completes the activation process if the connection is stable. If the MeterDog LED continues to flash for more than 3 minutes, move the antenna tip to try and improve cellular communication. A few inches this way or that way usually does the trick.

KONA LABS MeterDog Water Monitoring System - magnet2

KONA LABS logo

Documents / Resources

KONA LABS MeterDog Water Monitoring System [pdf] User Guide
MeterDog Water Monitoring System, MeterDog, Water Monitoring System, Monitoring System, System

References

Leave a comment

Your email address will not be published. Required fields are marked *