Super Bright LEDs STB-Ax Series LED Beacon Light User Manual
Important: Read all instructions prior to installation.
Product Overview
This document provides instructions and specifications for the Super Bright LEDs STB-Ax series LED Beacon Lights, including models STB-A4, STB-A56, and STB-A7.
Product Images and Dimensions
Three LED beacon lights are shown. The first, labeled STB-A4, has a height of 122mm (4.8 inches) and a base diameter of 130mm (5.1 inches). The second, labeled STB-A56, has a height of 171mm (6.7 inches) and a base diameter of 171mm (6.7 inches). The third, labeled STB-A7, has a height of 178mm (7.0 inches) and a base diameter of 171mm (6.7 inches).
Specifications
Environmental Specifications
| Specification | Value |
|---|---|
| Operating Voltage | 12-24 VDC |
| IP Rating | IP67 |
| Operating Temperature | -22° to 140° F (-30° to 60° C) |
Wiring
- Red wire: Positive
- Black wire: Negative
- Yellow wire: Pattern Change + Sync
Safety and Notes
- Ensure your vehicle's electrical system can handle the additional load. Using incompatible power sources may lead to malfunctions.
- Install beacon light in a location that does not interfere with airbags or vehicle sensors.
- Recognize local laws and regulations regarding the use of beacon lights on vehicles. In some areas, specific colors, patterns, or usage restrictions may apply.
- Use considerately to maintain road safety for all motorists. Excessive use can distract other drivers.
- Ensure proper wiring: Connect the red wire to positive and the black wire to negative. Reverse polarity protection is included.
- Certification approvals include UKCA, CE, ECE R10, ECE R65 TA1 (White LED amber lens), CISPR 25 Class 3, and SAE J845 Class 1 (White LED amber lens).
Flash Patterns
Cycle flash patterns with a single press of the red button inside the light fixture or cigarette plug.
- Single Flash
- Double Flash
- Quad Flash
- Octa Flash
- Single Flash - Slow
- Single Flash - Breathing
- Rotating Flash
A diagram shows a hand pressing a red button located inside a clear beacon light lens.
Mounting Instructions (3-Bolt Method)
- First, gather your materials, including the beacon, three bolts, a wrench or socket set, and a drill if needed.
- Choose a flat, unobstructed surface for mounting, and use the beacon base as a template to mark the bolt positions.
- Drill the holes, then align the beacon base with the drilled holes.
- Insert and tighten the bolts to secure the beacon in place. Note: Silicone sealant (NFXB-SEAL10ML) can be applied around the drilled holes, creating a waterproof seal between the beacon and surface.
- Connect the red wire to the positive power supply and the black wire to the negative. If there's a yellow wire, connect it for pattern control or synchronization. Note: Synchronization can be achieved by connecting all yellow wires together.
- Finally, power on the beacon to test its operation, ensuring it is securely mounted and functions properly.
Mounting Diagrams
A top-down view of the STB-A4 beacon base shows mounting hole positions, with dimensions indicating a diameter of 118mm and smaller hole diameters of 5.5mm, with angular markings at 120 degrees.
A top-down view of the STB-A56 and STB-A7 beacon bases shows mounting hole positions, with dimensions indicating a diameter of 150mm, hole diameters of 5.5mm and 7.5mm, and angular markings at 120 degrees.
A side view diagram illustrates the mounting process, showing the beacon unit, the mounting base with bolt holes, and bolts being inserted from below.
