DJI Mic 3 Quick Start Guide

Getting Started: Attaching the Transmitter

The DJI Mic 3 transmitter (TX) can be attached to clothing in two ways:

1. Using the Built-in Clip: Slide the transmitter's clip onto the edge of a shirt collar or pocket.
2. Using the Magnetic Back: Attach the magnetic adapter to the back of the transmitter, then place it on clothing. The magnet will secure it in place.

A windjammer can be attached to the transmitter's microphone for reduced wind noise.

Charging the Devices

Both the transmitter (TX) and receiver (RX) can be charged using USB-C cables. Connect the USB-C cable to the USB-C port on each device and to a power source.

Powering On and Pairing

Powering On: Press and hold the power button on both the TX and RX units for approximately 2 seconds until they turn on.

Pairing:

• With Smartphone: Connect the RX unit to a smartphone using the appropriate adapter. Open the DJI Mimo app on your smartphone. The system will automatically pair.
• With Camera: Follow the visual instructions to pair the TX and RX units with your camera.

Connecting to Cameras

Connecting to Cameras (e.g., DSLR/Mirrorless):

1. Attach the RX unit to the camera's hot shoe or mounting point.
2. Connect the RX unit's output port (labeled "OUT") to the camera's microphone input (MIC-IN) using a suitable cable.

Connecting to DJI Devices:

• The TX unit can be paired wirelessly with devices like the Osmo Action 4, Osmo Action 5 Pro, or Osmo Pocket 3.
• Press and hold the power button on the TX for 2 seconds to power it on.
• The TX will wirelessly connect to compatible DJI devices.

DJI Mimo App and Resources

For advanced features and settings, download the DJI Mimo app. Visit https://s.dji.com/guide111 for more detailed instructions.

Device Components (Receiver - RX)

The receiver unit (RX) features the following:

• 1. USB-C Port: For charging and data transfer.
• 2. Charging Contacts: For charging.
• 3. Monitor Port: For connecting headphones to monitor audio.
• 4. Output Port: For connecting to cameras, smartphones, or other recording devices.
• 5. Touchscreen: For adjusting settings and viewing status.
• 6. Dial: For navigating menus and adjusting parameters.
• 7. Power Button: To turn the device on/off.
• 8. Release Button: To detach the unit from its mount.

Device Components (Transmitter - TX)

The transmitter unit (TX) features the following:

• 1. Recording Status LED: Indicates recording status and battery level.
• 2. Charging Contacts: For charging.
• 3. System Status LED: Indicates system status and pairing information.
• 4. Power Button: To turn the device on/off.
• 5. Linking Button: Used for manual pairing procedures.

Basic Operations

• Power On/Off: Press and hold the power button for 2 seconds.
• Start/Stop Recording: Press the power button once.
• Linking: Press the linking button twice to initiate pairing.