លក្ខណៈបច្ចេកទេស
- Product Name: PG9938 Remote Panic Button
- Compatibility: IQ Panel 4 v4.5.2 and higher
- Functionality: Enrolled as audible or silent medical, or audible or silent intrusion alarm activation
IQ Panel 4 v4.5.2 and higher
The PG9938 remote panic button can be enrolled into an IQ4 panel as audible or silent medical, or audible or silent intrusion alarm activation for the system.
ដំណើរការចុះឈ្មោះ៖
ចុចឱ្យជាប់ 
button of the fob until the keyfob’s LED flashes amber
Tech Tip: If the LED flashes only once after holding for 10 seconds, or if it flashes multiple times the keyfob may have been enrolled into another panel.
លែងប៊ូតុង and press and hold again.
ការសរសេរកម្មវិធី៖
Settings > Advanced Settings > Installation > Devices > Security Sensors > Auto Learn Sensor
ចុចប៊ូតុងឱ្យជាប់ of the fob until the keyfob’s LED flashes amber
Program the ‘Sensor Group’, ‘Sensor Name’ and ‘Voice Prompts’ as needed.
Select “ADD NEW”.
Tech Tip: Do not program the PG9938 as a Fixed sensor group.
Select only:
- 1 – Mobile Intrusion
- 3 – Mobile Silent
- 6 – Mobile Auxiliary
- 7 – Mobile Silent Auxiliary
- 25 – Safety Auxiliary Pendent (non-alarm)
- (Set ‘Voice Prompts’ to OFF for no zone status annunciation)
- If a Fixed sensor group is used the zone may go into supervisory trouble after the supervision window has expired (default 24 hours.)
- When supervisory trouble occurs the History tab under Settings > Status will show “Failure” with a time and date stamp of the loss of supervision.
- In addition, the device tray on the arming page will show a for the zone.
សំណួរគេសួរញឹកញាប់
What should I do if the LED on the keyfob flashes only once or multiple times during enrollment?
If the LED flashes only once after holding for 10 seconds or multiple times, it may indicate that the keyfob has been enrolled in another panel. Release the button and try enrolling again.
ឯកសារ/ធនធាន
 |
IQ PANEL PG9938 Remote Panic Button [pdf] សៀវភៅណែនាំ PG9938, PG9938 Remote Panic Button, Remote Panic Button, Panic Button, Button |