Keychron K15 Pro Wireless Custom Mechanical Keyboard User Guide
If you are a Windows user, please find the appropriate keycaps in the box, then follow the instructions below to find and replace the following keycaps.
Switch To The Right System
Please make sure the system toggle on the top left corner has been switched to the same system as your computer’s operating system.
Connect Bluetooth
Press fn + 1 (for 4 seconds) and pair with device named Keychron K15 Pro.
Switch toggle to Bluetooth
Connect Cable:
The VIA Key Remapping Software
Please vist usevia.app to use the online VIA software to remap the keys Ifthe VIA cannot recogize your keyboard, please reach our support 1o get the instruction,
- The online VIA software can only run on the latest version of Chrome, Edge, and Opera browsers yet,
- VIA only works when the keyboard is connected by wire to the computer.
The Layan
‘There are four layers of key stings on the Keyboard. The layer 0 and Ayer 1 3reforthe Mac system. The layer 2and Ayer 3are for the Windows system.
If your system toggle stitched tombac, then the layer Owl be acthated
If your system toggle stitched to Windows, then the layer 2 will be activated. Remember that f you. are sing it n Windows mode, please make changes o the aye 2 instead of the op layer the flyer O, “This s a common mistake people are making.
The Backlight
Pres fin-+ To change the lighting effect
Press fn + tab to turn the backlight on/off
Adjust The Backlight Brightness
Press fin + W to increase the backlight brightness.
Press fen + S to decrease the backlight brightness
Adjust The Backlight Spec’d
Press + T to increase the light effect speed
Press fn + G to decrease the light effect speed
Watch T Building Tutorial On Our Website
If you are building the keyboard of the firth time, we highly. recommend you watch the bulling tutorial video on our website first, then start biding the keyboard yours.
Factory Reset
Troubleshooting? Don’t know what’s going on with the keyboard?
- Troubleshooting? Don’t know what’s going on with the keyboard? Plug in the power cable and switch the keyboard to Cable mode.
- Factory reset the keyboard by pressing fn + J + Z (for 4 seconds).
- Download the right firmware and QMK Toolbox from our website.
- Switch the keyboard to OFF mode and remove the space bar keycap to find the reset button on the PCB.
- Hold the reset key first, then switch the keyboard to Cable mode. Release the reset key, and the keyboard will now enter DFU mode.
- Flash the firmware with the QMK Toolbox.
- Factory reset the keyboard again by pressing fn +J+Z (for 4 seconds).
* Step by step guide can be found on our website.
Not Happy
Documents / Resources
 |
Keychron K15 Pro Wireless Custom Mechanical Keyboard [pdf] User Guide K15 Pro, K15 Pro Wireless Custom Mechanical Keyboard, Wireless Custom Mechanical Keyboard, Custom Mechanical Keyboard, Mechanical Keyboard, Keyboard |
 |
Keychron K15 Pro Wireless Custom Mechanical Keyboard [pdf] User Guide 2ASF4-K15PRO, 2ASF4K15PRO, K15 Pro, K15 Pro Wireless Custom Mechanical Keyboard, Wireless Custom Mechanical Keyboard, Custom Mechanical Keyboard, Mechanical Keyboard, Keyboard |