DLB01 Wireless Remote Control
Product Information
Specifications
- Product Name: Wireless Remote Control
- Compatibility: Works with the intelligent home security
system - Components: Intelligent home host, security alarm sensors
- Functionality: Control working mode of the host, operate the
host, ensure family safety - Regulatory Compliance: FCC Part 15
- Radiation Exposure Limits: Complies with FCC regulations for
uncontrolled environments
Product Usage Instructions
1. Setup and Installation
1. Ensure the intelligent home host is properly set up and
functioning.
2. Place the wireless remote control within the recommended
range of the host.
2. Operating the Remote Control
1. Press the designated buttons on the remote control to change
the working mode of the host.
2. Use the remote control to operate various sensors such as
magnetic door, curtain, gas detector, etc.
3. Safety Guidelines
1. Do not make any unauthorized changes or modifications to the
device.
2. Keep a minimum distance of 0cm between the device and your
body to comply with FCC regulations.
Frequently Asked Questions (FAQ)
Q: Can I use the wireless remote control with other security
systems?
A: The wireless remote control is specifically designed for use
with the intelligent home security system and may not be compatible
with other systems.
Q: How do I change the batteries in the remote control?
A: To change the batteries, locate the battery compartment on
the back of the remote control, remove the old batteries, and
insert new ones following the polarity markings.
Q: What should I do if the remote control is not working?
A: Check if the batteries are properly inserted and have
sufficient charge. Ensure there are no obstructions between the
remote control and the host. If issues persist, contact customer
support for assistance.
Wireless remote control manual
Intelligent home security system is composed of intelligent home host and security alarm series sensors. The security alarm sensor series can be divided into magnetic door, curtain, gas detector, smoke detector, human body infrared detector, leakage sensor, etc. Wireless remote control is used to control the working mode of the host, the operation of the host, to safeguard the safety of the family.
I. Specifications and parameters Wireless remote control Ø working voltage: 12 v battery Ø transmitting frequency: 433 MHZ Ø launch distance: more than 100 meters (empty range), Ø movement distance: 10 mm Ø static current: 1.5 uA or less Ø alarm current: 10 ma, or less
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Documents / Resources
 |
KERUI DLB01 Wireless Remote Control [pdf] User Manual 2AZI3-DLB01, 2AZI3DLB01, DLB01 Wireless Remote Control, DLB01, Wireless Remote Control, Remote Control, Control, Remote |