Keithy S03 Selfie Stick Tripod

Product Instruction

IC warning
This device contains license-exempt transmitters/receivers)/ that comply with Innovation Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. this device may not cause interference and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment; To maintain compliance with IC’s RF Exposure guidelines.
This device and its antenna(s) must not be co-located or in operation in conjunction with any other antenna or transmitter.

Battery Replacement

1. Separate the product from the side of the remote control
2. After replacing the battery, reverse assembly.

Remote Control Instruction

1. Hold and press the remote button 3 seconds to power on, LED indicator blinks.
2. Search and pair with BT name “SelfieCom” on your cellphone, LED indicator will stop flashing after successfully connected. Use the remote control to capture pictures or record videos, the LED flash once at a time.
3. The remote control will automatically shut down in 5 mins if not paired.
4.  The remote control will automatically sleep in 10 mins without any operation. And auto shut down after another 10 mins if not awakened.
5. Hold and press the remote button to power off, LED indicator flashes 3 times then shut down.

Led Light Instruction

1. Hold and press the selfie light power button for 3 seconds to power on/off.
2. Short press the selfie light power button to change LED brightness.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However. There is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help

NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure conditions without restriction.

Documents / Resources

Keithy S03 Selfie Stick Tripod [pdf] Instruction Manual S03, S03 Selfie Stick Tripod, Selfie Stick Tripod, Stick Tripod, Tripod

References

• User Manual