Keeson RC302E Remote Control User Manual

Keeson RC302E Remote Control

Specifications

Remote Control Overview

Button Functions

1. Head A up
   Press and hold HEAD A UP button of remote, head A actuator moves out, stop when released；
2. Head A down
   Press and hold HEAD A DOWN button of remote, head A actuator moves in, stop when released；
3. Head B up
   Press and hold HEAD B UP button of remote, head B actuator moves out, stop when released；
4.  Head B down
   Press and hold HEAD B DOWN button of remote, head B actuator moves in, stop when released；
5. Foot up
   Pressa and hold FOOT UP button of remote, foot actuator moves out, stop when released;
6. Foot down
   Press and hold FOOT DOWN button of remote, foot actuator moves in , stop when released；
7. UBB
   Click the Under bed light button to open or shut the light under the bed.
8.  Massage head +
   Click MASSAGE HEAD button, head massage motor switches massage intensity, massage intensity switches among 0-1-2-3；
9. Massage foot +
   Click MASSAGE Foot button, head massage motor switches massage intensity, massage intensity switches among 0-1-2-3；
10. Massage head –
    Clicking will cause the intensity of the head massage to gradually decrease, with a total of 3 levels.；
11.  Massage foot –
    Clicking will cause the foot massage intensity to cycle and decrease gradually, with a total of 3 levels.；
12.  Massage timer
    If the massage motors do not work, the button is invalid, if the massage motors work, click the button to switch the massage time, when massage time switch to 0, turn off the massage;
13. Flat
    Click FLAT button, the bed goes flat, stop when click any button during the process of going flat；
14. ZG button
    Click the ZG button, the actuator moves to ZG position, stop when click any button during the movement;
15. Memory position
    Click memory position to move the actuator to the memory position.

FCC STATEMENT

FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FAQs

• How do I adjust the head and foot positions?
  Use the “Head A Up/Down” and “Foot Up/Down” buttons to adjust the positions. Press and hold to move, release to stop.
• How can I change the massage intensity?
  Use the “Massage Head +” or “Massage Foot +” buttons to increase intensity, and the “-” buttons to decrease it.