Keeson MC320 Control Box Instruction Manual

Keeson MC320 Control Box

Function Picture

Product Name: CONTROL BOX
Model: MC320
Input: 29VDC, 1.8A, 52.2W
Manufacturer: Keeson Technology Corporation Limited
Manufacturing country: China

Pair

STEP 1

Unplug the Power Cord from your power outlet. Wait 1minute, then plug it back in to your power outlet. Perform Step 2 within 10 seconds, while the control box light is illuminating.

STEP 2

Press and hold the PAIR button on the back of the remote. The PAIR button will illuminate and start to flash. When the PAIR button stops flashing, the Pair LED light on the control box will stop flashing. Release the PAIR button.
The following functions can be performed only after the main control box is paired with the remote control.

Function

HEAD port

Connect to head actuator, control by remote single:
Click head up button on the remote, head actuator moves out, stop when released:
Click head down button, head actuator moves in, stop when released:
This function takes effect only by pressing the corresponding button on the remote.

FOOT port

Connect to foot actuator, control by remote single:
Click foot up button, foot actuator moves out, stop when released:
Click foot down button, foot actuator moves in, stop when released:
This function takes effect only by pressing the corresponding button on the remote.

MULTIFUNCTION port

Connect with Other accessories;

Power LED & PAIRING LED

Power supply for control box, PAIRING LED of control box flashes for 4 times, and then turns off, POWER LED turn on.

Power

Connect to the 29V DC;

UBL

Connect to the LED backlit logo board

FCC

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

ISED RSS Warning:

This device complies with Innovation, Science and Economic Development Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.