KAON PG2141 GPON Gateway

Quick installation guide

PG2141 is GPON ONT for FTTH Networks BoSAOn Board Optical Solution Smart Wi-Fi

Connect the Hardware

If your Internet connection is through an Ethernet cable from the wall instead of through a DSL/Cable modem, connect the Ethernet cable directly to the router’s Internet port, and skip Step 1,2,3 to complete the hardware connection.

FrontPanel 

Rear Panel 

LED Status

LED	Power up Initial	DS scan	DS locking	US ranging	Request CM IP	Request CM config	CMTS register Complete	Request MTA IP	Request MTA config	Restart Voice service	Telephone Register complete
Power	On	On	On	On	On	On	On	On	On	On	On
DS	Blinking	Blinking	On	On	On	On	On	On	On	On	On
US	Blinking	Off	Off	Blinking	On	On	On	On	On	On	On
ONLINE	Blinking	Off	Off	Off	Off	Blinking	On	On	On	On	On
2.4G/5G	Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off
ETH1~4	Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off	On/Off
TEL1~2	Off	Off	Off	Off	Off	Off	Off	Blinking	Blinking	Blinking	On

Connecting and Installing devices

Before installation, please check with your service provider to ensure that the cable broadband is active.

Instruction for Connecting Modem –PC

1. Make sure the following:
   1. YourCableModemispoweredON.ThepowerLEDwillbeturnedON.
   2. YourPCisturned-onandconnectedtoCableModemusinganEthernetcable.
   3. Connecttightlythecoaxialcabletothecableoutlet.
   4. After Online LED is ON, Cable Modem becomes online.
2. Configure your PC to obtain an IP address from a DHCP server.
3. From your PC, start your web browser application like Chrome, InternetExplorer, etc.
4.  Type avalidURLsuchas“www.kaonmedia.com”and<Enter>. The website should be open if connected correctly.

Package Content

Specification

Exterior Design

Documents / Resources

KAON PG2141 GPON Gateway [pdf] Installation Guide PG2141, 2AXCW-PG2141, GPON Gateway

References

• User Manual