KandM 18880 Keyboard Base Table Instructions
Instruction For Use
Warning:
Mount the side parts 7 at the same height -keyboard needs to be fully horizontal. Tighten all screws securely.
How to Set Up:
Pull the side parts 7 apart as far as they go and secure them with the locking screw 8.
Use the bolts 9 (M6 x 50 mm), washers 10 and locking nuts 11 to fasten the connecting brace 12 to the top of the side parts (Fig. A) and tighten it (Fig. B).
Press in the plastic end caps 13 and stick the rubber pads 14 onto the support arms.
Height-adjustment (12-way):
Remove end caps 2 and loosen locking parts (nuts 3, washers 4, bolts 5, 6). For the desired height insert the 4 bolts 5, 6 in the same hole on each base part 1.
Attention: Insert the hexagon bolts in the round holes, the square neck carriage bolts in the square holes.
Stick the side parts 7 onto the base parts 1 until they hit the bolts (Fig. C) and tighten with washers 4 and nuts 3. Press in the end caps 2.
To fold up the stand:
Loosen the locking nuts 11, fold out the connecting brace 12 and re tighten the locking nuts 11. Loosen the locking screw 8 and push the side parts 7 together. Secure with the locking screw 8.
Important Information:
If you place the stand inside your house, it may be advisable to put a non-sliding pad under the stand’s rubber end caps as they could leave marks on sensitive floors, for example parquet flooring.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
18880-000-55 Rev.01 9/19
Documents / Resources
 |
KandM 18880 Keyboard Base Table [pdf] Instructions 18880 Keyboard Base Table, 18880, Keyboard Base Table, Base Table |