LAMPU ACARA APRO4-IP DMX Controller

Kanggo safety sampeyan, waca manual pangguna iki kanthi teliti sadurunge digunakake.
Event Lighting duwe hak kanggo ngowahi manual ing sembarang wektu. Informasi lan spesifikasi ing manual iki bisa diganti tanpa kabar. Lighting Event ora tanggung jawab utawa tanggung jawab kanggo kesalahan utawa ngilangi. Mangga takon Lampu Acara kanggo klarifikasi utawa informasi babagan item iki.

FITUR

• DMX 512, RDM, Artnet and sACN support
• Konfigurasi remot liwat internal webkaca
• Update firmware on Webkaca
• DMX output isolation
• RJ45 Ethernet B input with POE（DC12V 2A）
• Layar LCD
• Gigabit network, 100/1000mbps port speed
• Rating IP65

PANEL OVERVIEW

1. Ethernet port RJ45
2. Ethernet port RJ45
3. Power in/out True1
4. 2xDMX5pin connectors
5. 2xDMX5pin connectors
6. nduwèni sekring
7. LCD Display protection cover

MENU
Below is controller Menus map

UtamaMenu	Submenu 1	Submenu 2	Nilai/Pilihan	Default
Jaringan	Mode IP		DHCP	Statis
			Statis
	Alamat IP		2.xx.xx.xx	2.xx.xx.xx
	Topeng Subnet		255.0.0.0	255.0.0.0
DMX Port	Protokol	Artnet		Artnet
		sACN
	Start Net		000-127	000
	Miwiti Universe		000-255	000
	Pelabuhan 1	Mode	Mati	On
			On
		NET	000-127	000
		Semesta	000-255	000
	Pelabuhan 2	Mode	Mati	On
			On
		NET	000-127	000
		Semesta	000-255	001
	Pelabuhan 3	Mode	Mati	On
			On
		NET	000-127	000
		Semesta	000-255	002
	Pelabuhan 4	Mode	Mati	On
			On
		NET	000-128	000
		Semesta	000-255	003
			Pateni
Setelan	Tarif DMX		20Hz	30Hz
			25Hz
			30Hz
			35Hz
			40Hz
	RDM	Pateni		Pateni
		Aktifake
	Tampilake	tansah		1 Min
		30Sec
		1 Min
		5 Min
	Sinyal Mundhut	Tahan DMX		Tahan DMX
		Stop Output
	Mode Gabungan	PH		PH
		LTP
	Reset pabrik	Ora		Ora
		ya wis

WEB konfigurasi

Mode IP jaringan piranti NET bisa disetel menyang mode DHCP utawa mode Statis.

Mode DHCP

• When APRO4‐IP is set to DHCP mode, you need to set the computer to DHCP also. And use a router for linking computer and APRO4‐IP device. The controller will show IP address like below:
• Ketik alamat IP ing web browser, banjur sampeyan bisa mlebu webkaca kanggo ngatur parameter controller.

Ketik sandhi: admin

Mode statis

• When APRO4‐IP device is set to Static mode, you need to set computer to be Static mode also. APRO4‐IP device will show IP address as below:
• Banjur nyetel alamat IP komputer ing kisaran IP sing padha kanthi manual. Kanggo example: IP address must start with 2 according to APRO4‐IP address. And netmask is same with 255.0.0.0.
• Input static IP address of APRO4‐IP device in your browser, then you can login to configure the parameter of device.

Ketik sandhi: admin

• Nalika mlebu ing NET Config web, the first page show the information about APRO4‐IP.
• Following  is  for  Network  setting,  you  can  set  IP  mode  to  be  Static  or  DHCP,  IP  Address,and Subnet Mask. After setting, click Save button .
• Kanggo kaca Port DMX, digunakake kanggo setelan Port DMX. Sampeyan bisa milih Protokol dadi Artnet utawa sACN, lan nyetel saben port minangka input utawa output.
• On the page of Setting , you can set DMX Rate, RDM , Display On and Signal Loss. After setting, click Save to store the setting.
• DMX  Rate:  You  can  set  20Hz,  25Hz,  30Hz,  35Hz,  40Hz,  30Hz  is default setting.
• RDM: You can set RDM to be Disable or Enable.
• There is 4 options for Display On mode: Always, 30Sec, 1Min, 5Min.
• Sinyal Mundhut: Can set as Hold DMX or Stop Output.
• Sampeyan bisa bali menyang setelan pabrik kanthi ngeklik tombol Reset Pabrik.
• Ing kaca Nganyari, sampeyan bisa nganyari piranti lunak piranti kanthi milih piranti lunak nganyari file of APRO4‐IP.
• Ing kaca pungkasan, sampeyan bisa ngreset sandhi.

SPESIFIKASI

• Daya ing: AC 100‐240V,50/60Hz
• konsumsi daya: AC 240V 50HZ 0.05A
• ukuran: 215.3×150.5x42mm 4.2W
• Bobot: 1.43Kg
• POE 802.3af
• IP65

DIMENSI

Garansi

Mangga deleng dealer lokal utawa hubungi Event Lighting. www.event‐lighting.com.au

Pitakonan sing Sering Ditakoni

How do I reset the APRO4-IP device to factory settings?

To perform a factory reset on the APRO4-IP device, access the Factory Reset option in the Main Menu under Settings. Confirm the reset to restore the device to its default configuration.

What is the default IP address for the APRO4-IP device?

The default IP address for the APRO4-IP device is set to DHCP mode. If you switch to Static mode, you can set a specific IP address within the range provided in the user manual.

Dokumen / Sumber Daya

LAMPU ACARA APRO4-IP DMX Controller [pdf] Manual pangguna APRO4-IP, APRO4-IP DMX Controller, DMX Controller, Controller

Referensi

• Manual pangguna